IN100-Q1-R-RC1F datasheet(25/49 Pages) ETC

25 / 49 page

24 / 47

www.inplay-tech.com

N1EDOC-DS-IN100-EN-V1.3

4.4.2. On-chip temperature monitoring

Measured at: Ta = 25°C, VCC= 3.0V, unless otherwise noted (If the on-chip temperature monitor is

used, VCC should not be greater than 3.0V)

Table 7 : Temperature Monitoring Characteristics

Parameter

Test Conditions

Min.

Typ.

Max.

Unit

Resolution

Using on-chip V0P8 as

reference

-0.4

°C/LSB

Range

-40

°C

Accuracy

With VREF calibration

-10

1.5

°C

4.4.3. MGPIO analog measurement

Measured at: Ta = 25°C, VREF=0.8V, VCC=3.0V, unless otherwise noted (If MGPIO analog

measurement is used, VCC should not be greater than 3.0V).

Table 8 : MGPIO Analog monitoring characteristics

Parameter

Test conditions

Min.

Typ.

Max.

Unit

Resolution

Using on-chip V0P8 as

reference

0.74

mV/ LSB

Range

Input range to the MGPIO

PIN is 0V – 1.6V (FS).

1.6

Accuracy

With VREF calibration only

-3.3

1.1

3.3

With ADC offset and VREF

calibration

-0.9

0.3

0.9

The device supports ADC value linear scaling to convert from raw voltage to the meaningful user

defined unit. For example, the device can convert a temperature sensor raw voltage output

captured by its ADC to a Celsius temperature unit.

4.5. Load switch - power supply control

The device also provides two load switch pins. Switch 0 (SW0) provides a low impedance path to

VCC when turned on, while Switch 1 (SW1) provides a low impedance path to ground when turned

on as shown in Figure 10.

IN100-Q1-R-RC1F датащи(PDF) 25 Page - List of Unclassifed Manufacturers

IN100-Q1-R-RC1F датащи(HTML) 25 Page - List of Unclassifed Manufacturers

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49

датащи скачать

ссылки URL