| поискавой системы для электроныых деталей |
|
CS61880 датащи(PDF) 28 Page - Cirrus Logic |
|
|
|||||||||||||||||||||||||||||
CS61880 датащи(HTML) 28 Page - Cirrus Logic |
|
28 / 70 page ![]() CS61880 28 DS450PP3 11. JITTER ATTENUATOR The CS61880 internal jitter attenuators can be switched into either the receive or transmit paths. Alternatively, it can be removed from both paths to reduce the propagation delay. During Hardware mode operation, the location of the jitter attenuator for all eight channels are con- trolled by the JASEL pin (Refer to Table 7 for pin configurations). The jitter attenuator’s FIFO length and corner frequency, can not be changed in hard- ware mode. The FIFO length and corner frequency are set to 32 bits and 1.25 Hz. During host mode operation, the location of the jit- ter attenuator for all eight channels are set by bits 0 and 1 in the Line Length Channel ID Register (10h) (See Section 14.17 on page 38). This register (0Fh) also configures the jitter attenuator’s FIFO length (bit 3) and corner frequency (bit 2). The attenuator consists of a 64-bit FIFO, a narrow- band monolithic PLL, and control logic. The jitter attenuator requires no external crystal. Signal jitter is absorbed in the FIFO which is designed to nei- ther overflow nor underflow. If overflow or underflow is imminent, the jitter transfer function is altered to ensure that no bit-er- rors occur. A configuration option is provided to reduce the jitter attenuator FIFO length from 64 bits to 32 bits in order to reduce propagation delay. The jitter attenuator -3 dB knee frequency depends on the settings of the Jitter Attenuator FIFO length and the Jitter Attenuator Corner Frequency, bits 2 and 3, in the Line Length Channel ID Register (10h) (See Section 14.17 on page 38)). Setting the lowest corner frequency guarantees jitter attenua- tion compliance to European specifications TBR 12/13 and ETS 300 011. The jitter attenuator is also compliant with ITU-T G.735, G.742, and G.783 (Refer to Figure 18 on page 56 and Figure 19 on page 57). Table 7. Jitter Attenuator Configurations PIN STATE JITTER ATTENUATOR POSITON LOW Transmit Path HIGH Receive Path OPEN Disabled |
|
ссылки URL |
| Вашему бизинису помогли Аллдатащит? [ DONATE ] |
Что такое Аллдатащит | реклама | контакт | Конфиденциальность | Ссылка на техническое описание | обмен ссыками | поиск по производителю All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |