M50FLW080A datasheet(31/64 Pages) STMICROELECTRONICS

31 / 64 page

M50FLW080A, M50FLW080B

Status Register

31/64

Status Register

The Status Register provides information on the current or previous Program or Erase

operation. The bits in the Status Register convey specific information about the progress of

the operation.

To read the Status Register, the Read Status Register command can be issued. The Status

commands are issued. The Status Register can be read from any address.

The text descriptions, below, should be read in conjunction with Table 14, where the

meanings of the Status Register bits are summarized.

5.1

Program/Erase Controller status (bit SR7)

This bit indicates whether the Program/Erase Controller is active or inactive. When the

Program/Erase Controller Status bit is ‘0’, the Program/Erase Controller is active; when the

bit is ‘1’, the Program/Erase Controller is inactive.

The Program/Erase Controller Status is ‘0’ immediately after a Program/Erase Suspend

command is issued, until the Program/Erase Controller pauses. After the Program/Erase

Controller pauses, the bit is ‘1’.

The end of a Program and Erase operation can be found by polling the Program/Erase

Controller Status bit can be polled. The other bits in the Status Register should not be tested

until the Program/Erase Controller has completed the operation (and the Program/Erase

Controller Status bit is ‘1’).

After the Program/Erase Controller has completed its operation, the Erase Status, Program

Status, VPP Status and Block/Sector Protection Status bits should be tested for errors.

5.2

Erase Suspend status (bit SR6)

This bit indicates that an Erase operation has been suspended, and that it is waiting to be

resumed. The Erase Suspend Status should only be considered valid when the

Program/Erase Controller Status bit is ‘1’ (Program/Erase Controller inactive). After a

Program/Erase Suspend command is issued, the memory may still complete the operation

rather than entering the Suspend mode.

When the Erase Suspend Status bit is ‘0’, the Program/Erase Controller is active or has

completed its operation. When the bit is ‘1’, a Program/Erase Suspend command has been

issued and the memory is waiting for a Program/Erase Resume command.

When a Program/Erase Resume command is issued, the Erase Suspend Status bit returns

to ‘0’.

M50FLW080A датащи(PDF) 31 Page - STMicroelectronics