| поискавой системы для электроныых деталей |
|
TLE9255WLC датащи(PDF) 23 Page - Infineon Technologies AG |
|
|
|||||||||||||||||||||||||||||
TLE9255WLC датащи(HTML) 23 Page - Infineon Technologies AG |
|
23 / 100 page ![]() Data Sheet 23 Rev. 1.02 2018-02-02 TLE9255W Modes of Operation 5.5 Power On Reset Power on Reset is a transition state of the TLE9255W after power is applied and the transceiver is not yet fully functional. • The transmitter and receiver are disabled. • The bus biasing is off. • The TxD timeout function is disabled. • The overtemperature protection is disabled. • The undervoltage detection on VBAT is enabled (Chapter 6.2.1), but it is not signalled in the SPI bit VBAT_UV. • The undervoltage detection on VCC is disabled. • The undervoltage detection on VIO is enabled (Chapter 6.2.4), but it is not signalled in the SPI bits VIO_LTUV and VIO_STUV. • The SPI communication is blocked (MOSI, SCLK, CSN), • RxD and MISO pins are high impedance. •TxD pin is blocked •If VBAT > VBAT_POD OR VCC > VCC_POD, then the INH output pin is switched on • All SPI registers are reset to default values. • The HS CAN bus is not continuously monitored for a valid wake-up pattern (Chapter 5.7.1) •The HS CAN bus is not monitored for a valid WUF (Chapter 5.7.2). • Local wake-up function is disabled. Conditions for entering the Power on Reset: •VBAT <VBAT_POD AND VCC <VCC_POD threshold. Conditions for leaving the Power on Reset: •If VBAT is within the functional range for at least tPON OR if VCC is within the functional range for at least tPON, then the TLE9255W enters Stand-by Mode Figure 14 shows power up behavior and power down behavior: Figure 14 Power down and power up behavior SPI bit POR The POR flag indicates that all registers are reset and the state machine is in the default mode (Stand-by Mode) If all of the following conditions are fulfilled, then the POR flag is set: •VBAT is within the functional range for at least tPON OR VCC is within the functional range for at least tPON, then the TLE9255W enters Stand-by Mode Power on Reset Any Mode VCC < VCC_POD AND VBAT < VBAT_POD Stand-by Mode VBAT OR VCC is in the functional range for at least tPON |
|
ссылки URL |
| Вашему бизинису помогли Аллдатащит? [ DONATE ] |
Что такое Аллдатащит | реклама | контакт | Конфиденциальность | Ссылка на техническое описание | обмен ссыками | поиск по производителю All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |