| поискавой системы для электроныых деталей |
|
TLE9255WLC датащи(PDF) 22 Page - Infineon Technologies AG |
|
|
|||||||||||||||||||||||||||||
TLE9255WLC датащи(HTML) 22 Page - Infineon Technologies AG |
|
22 / 100 page ![]() Data Sheet 22 Rev. 1.02 2018-02-02 TLE9255W Modes of Operation 5.4.3 Selective Sleep Sub-Mode Selective Sleep Sub-mode is a low power mode with optimized quiescent current. The following conditions are valid for the Selective Wake Sub-Mode: • The transmitter is disabled and the data available on the TxD input is blocked. • The default value of the RxD output pin depends on the power supply circuit of VIO. – Permanent power supply of VIO (INH pin is not used) The RxD output pin is “high” – The INH pin controls the power supply of VIO The RxD output pin is “low” • The bus biasing is off. • The TxD timeout function is disabled (Chapter 6.4). • The overtemperature protection is disabled (Chapter 6.5). • The undervoltage detection on VBAT (Chapter 6.2.1) is not signalled in the SPI bit VBAT_UV. • The undervoltage detection on VCC is disabled(Chapter 6.2.2). • The undervoltage detection on VIO (Chapter 6.2.4) is not signalled in the SPI bits VIO_LTUV and VIO_STUV. • The INH output pin is “low”. The SPI bit VBAT_CON in the register SWK_CTRL_1 controls the behavior of the INH pin. • The HS CAN bus is continuously monitored for a valid wake-up pattern (Chapter 5.7.1), but a valid wake-up pattern is not signalled in the SPI bit WUP (Chapter 5.7.1). •The HS CAN bus is not monitored for a valid WUF (Chapter 5.7.2). • Local wake-up function is enabled. Conditions for entering the Selective Sleep Sub-Mode: • If there is no communication on the HS CAN bus for longer than tSilence in the Selective Wake Sub-Mode, then the TLE9255W enters the Selective Sleep Sub-Mode. Conditions for leaving the Selective Sleep Sub-Mode: • If a WUP is detected, then Selective Wake Sub-Mode is entered. • If an LWU has been detected, then Stand-by Mode will be entered. • An SPI MC command triggers a mode change to any mode of operation. Figure 13 Mode change in Selective Sleep Sub-Mode Selective Sleep Sub-Mode (WUF detection in SPI configured) Selective Wake Sub-Mode Any Mode Selective Wake Sub-Mode tSilence expired WUP detection LWU detection Stand-by Mode SPI MC command |
|
ссылки URL |
| Вашему бизинису помогли Аллдатащит? [ DONATE ] |
Что такое Аллдатащит | реклама | контакт | Конфиденциальность | Ссылка на техническое описание | обмен ссыками | поиск по производителю All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |