CS61884 datasheet(42/72 Pages) CIRRUS

42 / 72 page

CS61884

DS485PP4

14.33 Status Registers

The following Status registers are read-only: LOS

Status Register (04h) (See Section 14.5 on

page 35), DFM Status Register (05h) (See Sec-

tion 14.6 on page 35) and AIS Status Register

(13h) (See Section 14.20 on page 39). The

CS61884 generates an interrupt on the INT pin any

time an unmasked status register bit changes.

14.33.1 Interrupt Enable Registers

The Interrupt Enable registers: LOS Interrupt En-

able Register (06h) (See Section 14.7 on page 36),

DFM Interrupt Enable Register (07h) (See Sec-

tion 14.8 on page 36), AIS Interrupt Enable Reg-

ister (14h) (See Section 14.21 on page 39) and

AWG Overflow Interrupt Enable Register

(1Ah) (See Section 14.27 on page 41), enable

changes in status register state to cause an interrupt

on the INT pin. Interrupts are maskable on a per

channel basis. When an Interrupt Enable register

bit is 0, the corresponding Status register bit is dis-

abled from causing an interrupt on the INT pin.

NOTE: Disabling an interrupt has no effect on the sta-

tus reflected in the associated status register.

14.33.2 Interrupt Status Registers

The following interrupt status registers: LOS In-

terrupt Status Register (08h) (See Section 14.9

on page 36), DFM Interrupt Status Register

(09h) (See Section 14.10 on page 36), AIS Inter-

rupt Status Register (15h) (See Section 14.22 on

page 40) and AWG Overflow Interrupt Status

dicate a change in status of the corresponding status

registers in host mode. Reading these registers

clears the interrupt, which deactivates the INT pin.

CS61884 датащи(PDF) 42 Page - Cirrus Logic