WM8737 datasheet(31/38 Pages) WOLFSON

31 / 38 page

Preliminary Technical Data

WM8737L

AI Rev 3.0 May 2004

Figure 16 2-Wire Serial Control Interface

The WM8737L has two possible device addresses, which can be selected using the CSB pin.

CSB STATE

DEVICE ADDRESS

Low or Unconnected

0011010

High

0011011

Table 18 2-Wire MPU Interface Address Selection

POWER SUPPLIES

The WM8737L can use up to four separate power supplies:

•

AVDD/AGND: Analogue supply, powers all analogue functions except the microphone pre-amp

and MICBIAS. AVDD can range from 1.8V to 3.6V and has the most significant impact on

overall power consumption. A large AVDD improves audio quality by increasing the maximum

input signal range and thus SNR.

•

MVDD: Supply pin for microphone pre-amp and MICBIAS only. This separate pin makes it

possible to generate MICBIAS voltages larger than AVDD up to a maximum of 3.6V. If this is

not necessary, MVDD should also be tied to AVDD.

•

DCVDD: Digital core supply, powers all digital functions except the audio and control interface

pins. DCVDD can range from 1.42V to 3.6V, and has no effect on audio quality. The return

path for DCVDD is DGND, which is shared with DBVDD.

•

DBVDD: Digital buffer supply, powers the audio and control interface pins. This makes it

possible to run the digital core at very low voltages, saving power, while interfacing to other

digital devices using a higher voltage. DBVDD draws much less power than DCVDD, and has

no effect on audio quality. The return path for DBVDD is DGND, which is shared with DCVDD.

It is possible to use the same supply voltage on all three. However, digital and analogue supplies

should be routed and decoupled separately to keep digital switching noise out of the analogue signal

paths.

POWER MANAGEMENT

The WM8737L has a power management register that allows users to select which functions are

active. For minimum power consumption, unused functions should be disabled. To avoid any pop or

click noise.

When the WM8737L is not in use, it can be put into either one of two standby modes or OFF mode.

OFF mode is achieved by writing zeros to all bits in the power management register and gives lowest

power consumption, but wake-up may take several seconds if the VMID decoupling capacitor has

discharged, as it must be recharged from the selectable impedance VMID source.

The output impedance of VMID can be changed to allow variable voltage stabilization time after

VMID is powered on. The 300kΩ setting will ensure minimum VMID power consumption but with slow

charging time, while the 2.5kΩ setting will allow a more rapid charging time but with the penalty of

greatly increased VMID power consumption. The default 75kΩ setting is recommended for most

applications.

ADDRESS

BIT

LABEL

DEFAULT

DESCRIPTION

R10 (0Ah)

VMID

Impedance

Control

3:2

VMIDSEL

VMID impedance selection control

00: 75kΩ output

01: 300kΩ output

10: 2.5kΩ output

Table 19 VMID Impedance Selection

WM8737 датащи(PDF) 31 Page - Wolfson Microelectronics plc

WM8737 датащи(HTML) 31 Page - Wolfson Microelectronics plc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38

датащи скачать

ссылки URL