STM32F446RC datasheet(150/201 Pages) STMICROELECTRONICS

150 / 201 page

Electrical characteristics

STM32F446xC/E

150/201

DocID027107 Rev 5

Figure 49. 12-bit buffered/non-buffered DAC

1. The DAC integrates an output buffer that can be used to reduce the output impedance and to drive external

loads directly without the use of an external operational amplifier. The buffer can be bypassed by

configuring the BOFFx bit in the DAC_CR register.

Gain

error(4)

Gain error

±0.5

Given for the DAC in 12-bit configuration

tSETTLING(4)

Total Harmonic Distortion

Buffer ON

-3

µs

CLOAD ≤ 50 pF,

RLOAD ≥ 5 kΩ

THD(4)

CLOAD ≤ 50 pF,

RLOAD ≥ 5 kΩ

Update

rate(2)

Max frequency for a correct

DAC_OUT change when

small variation in the input

code (from code i to i+1LSB)

MS/s

CLOAD ≤ 50 pF,

RLOAD ≥ 5 kΩ

tWAKEUP(4)

Wakeup time from off state

(Setting the ENx bit in the

DAC Control register)

6.5

µs

CLOAD ≤ 50 pF, RLOAD ≥ 5 kΩ

input code between lowest and highest

possible ones.

PSRR+ (2)

Power supply rejection ratio

(to VDDA) (static DC

measurement)

–67

–40

No RLOAD, CLOAD = 50 pF

1. VDDA minimum value of 1.7 V is obtained with the use of an external power supply supervisor (refer to Section 3.16.2:

Internal reset OFF).

2. Guaranteed by design.

3. The quiescent mode corresponds to a state where the DAC maintains a stable output level to ensure that no dynamic

consumption occurs.

4. Guaranteed based on test during characterization.

Table 85. DAC characteristics (continued)

Symbol

Parameter

Min

Typ

Max

Unit

Comments

STM32F446RC датащи(PDF) 150 Page - STMicroelectronics

STM32F446RC датащи(HTML) 150 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

датащи скачать

ссылки URL