IO20PDB0V0 datasheet(20/197 Pages) MICROSEMI

20 / 197 page

SmartFusion DC and Switching Characteristics

2- 8

R ev isio n 1 2

Theta-JA

Junction-to-ambient thermal resistance (

θJA) is determined under standard conditions specified by

JEDEC (JESD-51), but it has little relevance in actual performance of the product. It should be used with

caution but is useful for comparing the thermal performance of one package to another.

A sample calculation showing the maximum power dissipation allowed for the A2F200-FG484 package

under forced convection of 1.0 m/s and 75°C ambient temperature is as follows:

EQ 4

where

EQ 5

The power consumption of a device can be calculated using the Microsemi SoC Products Group power

calculator. The device's power consumption must be lower than the calculated maximum power

dissipation by the package. If the power consumption is higher than the device's maximum allowable

power dissipation, a heat sink can be attached on top of the case, or the airflow inside the system must

be increased.

Theta-JB

Junction-to-board thermal resistance (

θJB) measures the ability of the package to dissipate heat from the

surface of the chip to the PCB. As defined by the JEDEC (JESD-51) standard, the thermal resistance

from junction to board uses an isothermal ring cold plate zone concept. The ring cold plate is simply a

means to generate an isothermal boundary condition at the perimeter. The cold plate is mounted on a

JEDEC standard board with a minimum distance of 5.0 mm away from the package edge.

Theta-JC

Junction-to-case thermal resistance (

θJC) measures the ability of a device to dissipate heat from the

surface of the chip to the top or bottom surface of the package. It is applicable for packages used with

external heat sinks. Constant temperature is applied to the surface in consideration and acts as a

boundary condition. This only applies to situations where all or nearly all of the heat is dissipated through

the surface in consideration.

Calculation for Heat Sink

For example, in a design implemented in an A2F200-FG484 package with 2.5 m/s airflow, the power

consumption value using the power calculator is 3.00 W. The user-dependent Ta and Tj are given as

follows:

From the datasheet:

θJA = 19.00°C/W (taken from Table 2-6 on page 2-7).

= 75.00°C

TJ = 100.00°C

TA = 70.00°C

θJA = 17.00°C/W

θJC = 8.28°C/W

Maximum Power Allowed

TJ(MAX) TA(MAX)

–

θJA

---------------------------------------------

Maximum Power Allowed

100.00°C 75.00°C

–

19.00°C/W

----------------------------------------------------

1.3 W

IO20PDB0V0 датащи(PDF) 20 Page - Microsemi Corporation

IO20PDB0V0 датащи(HTML) 20 Page - Microsemi Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

датащи скачать

ссылки URL