CS4218 datasheet(38/44 Pages) CIRRUS

38 / 44 page

Appendix A: CS4218 Compatibility with CS4216

IMPORTANT !!

If you are upgrading your design from the CS4216 to the CS4218, please make sure to read this entire

appendix. The CS4218 is pin compatible with the CS4216. This appendix provides a summary of

differences between the two codecs.

Pin Compatibility

The CS4218 is 100% pin compatible with the CS4216 when used in Serial Modes 3 and 4. The

differences are noted in the following paragraphs and tables.

The CS4218 integrates the 600-ohm series resistors for the LOUT and ROUT analog outputs on the IC

itself. For the CS4216, these resistors are not on-chip, and need to be provided externally.

The CS4218 pin named SMODE3 does not incorporate an on-chip pull-down resistor, as is provided

on the CS4216 Rev B and later. This pin must be tied high or low, or driven by control logic to the

desired state (depends on the serial mode used). If this pin is left floating, the codec will not work

correctly.

The CS4218 adds the pin named FILT. On the CS4216, this pin is a no connect. The FILT pin is only

used when employing the SM3 Multiplier sub-mode. When using this sub-mode, a 0.47uF capacitor

must be connected from the FILT pin to AGND. When not using the Multiplier sub-mode, this pin may

remain unconnected.

Serial Modes

The CS4218 supports Serial Modes 3 and 4 of the CS4216. In addition, the CS4218 provides the SM3

Multiplier sub-mode and Serial Mode 5, which are not provided on the CS4216.

The CS4218 does not support Serial Modes 1 and 2 of the CS4216.

Decimation and Interpolator Filter Responses

The CS4218 and CS4216 use different digital filters for the ADC decimators and DAC interpolators.

Tables A1 and A2 provide a comparison between each codec’s filter responses.

CS4218

DS135F1

CS4218 датащи(PDF) 38 Page - Cirrus Logic