TAS5706APAPR datasheet(52/71 Pages) TI1

52 / 71 page

OSCILLATOR TRIM REGISTER (0x1B)

Oscillator Trim Enable Procedure Example

BKND_ERR REGISTER (0x1C)

TAS5706A

TAS5706B

SLOS606D – MARCH 2009 – REVISED SEPTEMBER 2009............................................................................................................................................. www.ti.com

The TAS5706A PWM processor contains an internal oscillator for PLL reference. This reduces system cost

because an external reference is not required. Currently, TI recommends a trim resistor value of 18.2 k

Ω (1%).

This should be connected between OSC_RES and DVSS.

The factory-trim procedure simply enables the factory trim that was previously done at the factory.

Note that trim always must be run following reset of the device.

Write data 0x00 to register 0x1B (enable factory trim).

Table 17. Oscillator Trim Register (0x1B)

FUNCTION

–

Reserved (1)

–

Oscillator trim not done (read-only) (1)

–

Oscillator trim done (read only)

–

Reserved (1)

–

Select factory trim (Write a 0 to select factory trim; default is 1.)

–

Factory trim disabled (1)

–

Reserved (1)

(1)

Default values are in bold.

When a back-end error signal is received (BKND_ERR = LOW), all the output stages are reset by setting all

PWM, VALID1, and VALID2 signals LOW. Subsequently, the modulator waits approximately for the time listed in

Table 18 before initiation of a reset.

Table 18. BKND_ERR Register (0x1C)

FUNCTION

–

Set back-end reset period to 0 ms (Reserved)

–

Set back-end reset period to 150 ms (Reserved)

–

Set back-end reset period to 299 ms (1)

–

Set back-end reset period to 449 ms

–

Set back-end reset period to 598 ms

–

Set back-end reset period to 748 ms

–

Set back-end reset period to 898 ms

–

Set back-end reset period to 1047 ms

–

Set back-end reset period to 1197 ms

–

Set back-end reset period to 1346 ms

–

Set back-end reset period to 1496 ms

–

Set back-end reset period to 1496 ms

–

Set back-end reset period to 1496 ms

(1)

Default values are in bold.

Submit Documentation Feedback

Product Folder Link(s): TAS5706A TAS5706B

TAS5706A is Not Recommended for New Designs

TAS5706APAPR датащи(PDF) 52 Page - Texas Instruments

TAS5706APAPR датащи(HTML) 52 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71

датащи скачать

ссылки URL