STM32L151RDT6 datasheet(24/140 Pages) STMICROELECTRONICS

24 / 140 page

Functional overview

STM32L151xD STM32L152xD

24/140

Doc ID 022027 Rev 6

3.7

Memories

The STM32L15xxD devices have the following features:

●

48 Kbytes of embedded RAM accessed (read/write) at CPU clock speed with 0 wait

states. With the enhanced bus matrix, operating the RAM does not lead to any

performance penalty during accesses to the system bus (AHB and APB buses).

●

The non-volatile memory is divided into three arrays:

–

384 Kbytes of embedded Flash program memory

–

12 Kbytes of data EEPROM

–

Options bytes

Flash program and data EEPROM are divided into two banks, this enables writing in

one bank while running code or reading data in the other bank.

The options bytes are used to write-protect the memory (with 4 KB granularity) and/or

readout-protect the whole memory with the following options:

–

Level 0: no readout protection

–

Level 1: memory readout protection, the Flash memory cannot be read from or

written to if either debug features are connected or boot in RAM is selected

–

Level 2: chip readout protection, debug features (Cortex-M3 JTAG and serial wire)

and boot in RAM selection disabled (JTAG fuse)

The whole non-volatile memory embeds the error correction code (ECC) feature.

3.8

FSMC (flexible static memory controller)

The FSMC supports the following modes: SRAM, PSRAM, NOR/OneNAND Flash.

Functionality overview:

●

Up to 26 bit address bus

●

Up to 16-bit data bus

●

Write FIFO

●

Burst mode

●

Code execution from external memory

●

Four chip select signals

●

Up to 32 MHz external access

3.9

DMA (direct memory access)

The flexible 12-channel, general-purpose DMA is able to manage memory-to-memory,

peripheral-to-memory and memory-to-peripheral transfers. The DMA controller supports

circular buffer management, avoiding the generation of interrupts when the controller

reaches the end of the buffer.

Each channel is connected to dedicated hardware DMA requests, with software trigger

support for each channel. Configuration is done by software and transfer sizes between

source and destination are independent.

The DMA can be used with the main peripherals: SPI, I2C, USART, SDIO, general-purpose

timers, DAC and ADC.

STM32L151RDT6 датащи(PDF) 24 Page - STMicroelectronics

STM32L151RDT6 датащи(HTML) 24 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

датащи скачать

ссылки URL