PCAL9535APW datasheet(5/46 Pages) NXP

5 / 46 page

PCAL9535A

All information provided in this document is subject to legal disclaimers.

Product data sheet

Rev. 1 — 28 September 2012

5 of 46

NXP Semiconductors

PCAL9535A

Low-voltage 16-bit I2C-bus I/O port with interrupt and Agile I/O

[1]

HWQFN24 package die supply ground is connected to both VSS pin and exposed center pad. VSS pin must

be connected to supply ground for proper device operation. For enhanced thermal, electrical, and board

level performance, the exposed pad needs to be soldered to the board using a corresponding thermal pad

on the board and for proper heat conduction through the board, thermal vias need to be incorporated in the

PCB in the thermal pad region.

[2]

Pins P0_0 to P0_7 correspond to bits P0.0 to P0.7. At power-up, all I/O are configured as high-impedance

inputs.

[3]

Pins P1_0 to P1_7 correspond to bits P1.0 to P1.7. At power-up, all I/O are configured as high-impedance

inputs.

Functional description

Refer to Figure 1 “Block diagram of PCAL9535A”.

6.1 Device address

A2, A1 and A0 are the hardware address package pins and are held to either HIGH

(logic 1) or LOW (logic 0) to assign one of the eight possible slave addresses. The last bit

of the slave address (R/W) defines the operation (read or write) to be performed. A HIGH

(logic 1) selects a read operation, while a LOW (logic 0) selects a write operation.

6.2 Registers

6.2.1 Pointer register and command byte

Following the successful acknowledgement of the address byte, the bus master sends a

command byte, which is stored in the Pointer register in the PCAL9535A. The lower

three bits of this data byte state the operation (read or write) and the internal registers

(Input, Output, Polarity Inversion, or Configuration) that will be affected. Bit 6 in

conjunction with the lower four bits of the Command byte are used to point to the

extended features of the device (Agile I/O). This register is write only.

P1_7[3]

I/O

Port 1 input/output 7.

Address input 0. Connect directly to VDD or VSS.

SCL

Serial clock bus. Connect to VDD through a

pull-up resistor.

SDA

I/O

Serial data bus. Connect to VDD through a

pull-up resistor.

VDD

power

Supply voltage.

Table 3.

Pin description …continued

Symbol

Type

Description

TSSOP24

HWQFN24

Fig 4.

PCAL9535A device address

R/W

002aah371

hardware

selectable

slave address

fixed

PCAL9535APW датащи(PDF) 5 Page - NXP Semiconductors

PCAL9535APW датащи(HTML) 5 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46

датащи скачать

ссылки URL