WM9712CLGEFLSLASHV datasheet(57/78 Pages) WOLFSON

57 / 78 page

Production Data

WM9712L

PD, Rev 4.6, November 2011

LOW POWER STANDBY MODE

If all the bits in registers 26h and 24h are set, then the WM9712L is in low-power standby mode and

consumes very little current. A 1M

 resistor string remains connected across AVDD to generate

VREF. This is necessary if the on-chip analogue comparators are used (see “Battery Alarm and

Battery Measurement” section), and helps shorten the delay between wake-up and playback

readiness. If VREF is not required, the 1M

 resistor string can be disabled by setting the SVD bit,

reducing current consumption further.

ADDRESS

BIT

LABEL

DEFAULT

DESCRIPTION

58h

SVD

VREF Disable

0: VREF enabled using 1M

 string (low-power

standby mode)

1 : VREF disabled, 1M

 string disconnected

(OFF mode)

Table 43 Disabling VREF (for lowest possible power consumption)

SAVING POWER AT LOW SUPPLY VOLTAGES

The analogue supplies to the WM9712L can run from 1.8V to 3.6V. By default, all analogue circuitry

on the IC is optimized to run at 3.3V. This set-up is also good for all other supply voltages down to

1.8V. However, at lower voltages, it is possible to save power by reducing the internal bias currents

used in the analogue circuitry. This is controlled as shown below.

ADDRESS

BIT

LABEL

DEFAULT

DESCRIPTION

5Ch

6:5

VBIAS

Analogue Bias optimization

11 : Lowest bias current, optimized for 1.8V

10 : Low bias current, optimized for 2.5V

01, 00 : Default bias current, optimized for 3.3V

Table 44 Analogue Bias Selection

WM9712CLGEFL/V датащи(PDF) 57 Page - Wolfson Microelectronics plc

WM9712CLGEFL/V датащи(HTML) 57 Page - Wolfson Microelectronics plc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78

датащи скачать

ссылки URL