UCD3138 datasheet(40/68 Pages) TI1

40 / 68 page

UCD3138

SLUSAP2 A – MARCH 2012 – REVISED MARCH 2012

www.ti.com

4.11 Sync FET Ramp and IDE Calculation

The UCD3138 has built in logic for controlling MOSFETs for synchronous rectification (Sync FETs). This

comes in two forms:

•

Sync FET ramp

•

Ideal Diode Emulation (IDE) calculation

When starting up a power supply, sometimes there is already a voltage on the output – this is called

prebias. It is very difficult to calculate the ideal Sync FET on-time for this case. If it is not calculated

correctly, it may pull down the pre-bias voltage, causing the power supply to sink current.

To avoid this, Sync FETs are not turned on until after the power supply has ramped up to the nominal

voltage. The Sync FETs are turned on gradually in order to avoid an output voltage glitch. The Sync FET

Ramp logic can be used to turn them on at a rate below the bandwidth of the filter.

In discontinuous mode, the ideal on-time for the Sync FETs is a function of Vin, Vout, and the primary side

duty cycle (D). The IDE logic in the UCD3138 takes Vin and Vout data from the firmware and combines it

with D data from the filter hardware. It uses this information to calculate the ideal on-time for the Sync

FETs.

4.12 Automatic Mode Switching

Automatic Mode switching enables the DPWM module to switch between modes automatically, with no

firmware intervention. This is useful to increase efficiency and power range. The following paragraphs

describe phase-shifted full bridge and LLC examples:

4.12.1 Phase Shifted Full Bridge Example

In phase shifted full bridge topologies, efficiency can be increased by using pulse width modulation, rather

than phase shift, at light load. This is shown below:

Functional Overview

Submit Documentation Feedback

Product Folder Link(s): UCD3138

UCD3138 датащи(PDF) 40 Page - Texas Instruments