SST25VF080B datasheet(5/32 Pages) SST

5 / 32 page

Data Sheet

8 Mbit SPI Serial Flash

SST25VF080B

S71296-04-000

01/10

Hold Operation

The HOLD# pin is used to pause a serial sequence under-

way with the SPI flash memory without resetting the clock-

ing sequence. To activate the HOLD# mode, CE# must be

in active low state. The HOLD# mode begins when the

SCK active low state coincides with the falling edge of the

HOLD# signal. The HOLD mode ends when the HOLD#

signal’s rising edge coincides with the SCK active low state.

If the falling edge of the HOLD# signal does not coincide

with the SCK active low state, then the device enters Hold

mode when the SCK next reaches the active low state.

Similarly, if the rising edge of the HOLD# signal does not

coincide with the SCK active low state, then the device

exits in Hold mode when the SCK next reaches the active

low state. See Figure 4 for Hold Condition waveform.

Once the device enters Hold mode, SO will be in high-

impedance state while SI and SCK can be VIL or VIH.

If CE# is driven active high during a Hold condition, it resets

the internal logic of the device. As long as HOLD# signal is

low, the memory remains in the Hold condition. To resume

communication with the device, HOLD# must be driven

active high, and CE# must be driven active low. See Figure

24 for Hold timing.

FIGURE 4: Hold Condition Waveform

Write Protection

SST25VF080B provides software Write protection. The

Write Protect pin (WP#) enables or disables the lock-down

function of the status register. The Block-Protection bits

(BP3, BP2, BP1, BP0, and BPL) in the status register pro-

vide Write protection to the memory array and the status

Write Protect Pin (WP#)

The Write Protect (WP#) pin enables the lock-down func-

tion of the BPL bit (bit 7) in the status register. When WP#

is driven low, the execution of the Write-Status-Register

(WRSR) instruction is determined by the value of the BPL

bit (see Table 2). When WP# is high, the lock-down func-

tion of the BPL bit is disabled.

Active

Hold

Active

Hold

Active

1296 HoldCond.0

SCK

HOLD#

TABLE

2: Conditions to execute Write-Status-

WP#

BPL

Execute WRSR Instruction

Not Allowed

Allowed

T2.0 1296

SST25VF080B датащи(PDF) 5 Page - Silicon Storage Technology, Inc

SST25VF080B датащи(HTML) 5 Page - Silicon Storage Technology, Inc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32

датащи скачать

ссылки URL