ATmega169P datasheet(252/393 Pages) ATMEL

номер детали	ATmega169P

подробное описание детали	8-bit Microcontroller with 16K Bytes In-System Programmable Flash

PDF	393 Pages

Scroll/Zoom	100%

производитель	ATMEL [ATMEL Corporation]

домашняя страница	http://www.atmel.com

Logo

252 / 393 page

252

8018N–AVR–08/09

ATmega169P

24.2

TAP – Test Access Port

The JTAG interface is accessed through four of the AVR’s pins. In JTAG terminology, these pins

constitute the Test Access Port – TAP. These pins are:

• TMS: Test mode select. This pin is used for navigating through the TAP-controller state

machine.

• TCK: Test Clock. JTAG operation is synchronous to TCK.

• TDI: Test Data In. Serial input data to be shifted in to the Instruction Register or Data Register

(Scan Chains).

• TDO: Test Data Out. Serial output data from Instruction Register or Data Register.

The IEEE std. 1149.1 also specifies an optional TAP signal; TRST – Test ReSeT – which is not

provided.

When the JTAGEN fuse is unprogrammed, these four TAP pins are normal port pins and the

TAP controller is in reset. When programmed and the JTD bit in MCUCSR is cleared, the TAP

pins are internally pulled high and the JTAG is enabled for Boundary-scan and programming.

The device is shipped with this fuse programmed.

For the On-chip Debug system, in addition to the JTAG interface pins, the RESET pin is moni-

tored by the debugger to be able to detect external reset sources. The debugger can also pull

the RESET pin low to reset the whole system, assuming only open collectors on the reset line

are used in the application.

ATmega169P датащи(PDF) 252 Page - ATMEL Corporation