MCP4017 datasheet(4/66 Pages) MICROCHIP

4 / 66 page

MCP4017/18/19

DS22147A-page 4

AC/DC CHARACTERISTICS

DC Characteristics

Standard Operating Conditions (unless otherwise specified)

Operating Temperature

–40°C

≤ TA ≤ +125°C (extended)

All parameters apply across the specified operating ranges unless noted.

VDD = +2.7V to 5.5V, 5 kΩ, 10 kΩ, 50 kΩ, 100 kΩ devices.

Typical specifications represent values for VDD = 5.5V, TA = +25°C.

Parameters

Sym

Min

Typ

Max

Units

Conditions

Supply Voltage

VDD

2.7

—

5.5

Analog Characteristics specified

1.8

—

5.5

Digital Characteristics specified

VDD Start Voltage

to ensure Wiper

Reset

VBOR

—

1.65

RAM retention voltage (VRAM) < VBOR

VDD Rise Rate to

ensure Power-on

Reset

VDDRR

(Note 7)V/ms

Delay after device

exits the reset

state

(VDD > VBOR)

TBORD

—10

µS

Supply Current

(Note 8)

IDD

—

µA

Serial Interface Active,

Write all 0’s to Volatile Wiper

VDD = 5.5V, FSCL = 400 kHz

—

2.5

µA

Serial Interface Inactive,

(Stop condition, SCL = SDA = VIH),

Wiper = 0, VDD = 5.5V

Note 1: Resistance is defined as the resistance between terminal A to terminal B.

2: INL and DNL are measured at VW with VA = VDD and VB = VSS.

3: MCP4018 device only, includes VWZSE and VWFSE.

4: Resistor terminals A, W and B’s polarity with respect to each other is not restricted.

5: This specification by design.

6: Non-linearity is affected by wiper resistance (RW), which changes significantly over voltage and

temperature.

7: POR/BOR is not rate dependent.

8: Supply current is independent of current through the resistor network

MCP4017 датащи(PDF) 4 Page - Microchip Technology

MCP4017 датащи(HTML) 4 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66

датащи скачать

ссылки URL