| поискавой системы для электроныых деталей |
|
HC210 датащи(PDF) 35 Page - Altera Corporation |
|
|
|||||||||||||||||||||||||||||
HC210 датащи(HTML) 35 Page - Altera Corporation |
|
35 / 228 page ![]() Altera Corporation 2–27 September 2008 Preliminary Power-Up Modes Power-Up Modes The functionality of structured ASICs is determined before they are produced. Therefore, they do not require programmability. HardCopy II structured ASICs follow the same principle, enabling traditional ASIC-like power up. Although prototyping FPGAs require configuration upon power up, the HardCopy II structured ASICs do not need to be configured. HardCopy II devices do not support configuration and designers should take this into account in the prototyping-to-production development process. The HardCopy II device does not require a configuration device, but you must ensure that the nCE pin is low and that the nCONFIG and nSTATUS pins are high after power up. 1 HardCopy II devices do not support FPGA configuration emulation and other configuration modes, including remote system upgrades and design security using configuration bitstream encryption. HardCopy II devices support both instant on and instant on after 50 ms power-up modes. In the instant on power-up mode, the HardCopy II device is available for use shortly after the device powers up to a safe operating voltage. The on-chip power-on reset (POR) circuit will reset all registers. The nCE, nCONFIG, and nSTATUS signals must be at the appropriate logic levels for the CONF_DONE output to be tristated once the POR has elapsed. This option is similar to an ASIC’s functionality upon power up and is the most likely scenario in production. In the instant on after 50 ms power-up mode, the HardCopy II device behaves similarly to the instant on mode, except that there is an additional delay of 50 ms, during which time the device will be held in reset. The CONF_DONE output is pulled low during this time, and then tri-stated after the 50 ms have elapsed. f For more information about which power-up modes HardCopy II devices support, refer to the Power-Up Modes and Configuration Emulation in HardCopy Series Devices chapter in the HardCopy Series Handbook. |
|
ссылки URL |
| Вашему бизинису помогли Аллдатащит? [ DONATE ] |
Что такое Аллдатащит | реклама | контакт | Конфиденциальность | Ссылка на техническое описание | обмен ссыками | поиск по производителю All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |