H8S2245 datasheet(169/818 Pages) RENESAS

169 / 818 page

Section 5 Interrupt Controller

Rev.3.00 Mar. 26, 2007 Page 127 of 772

REJ09B0355-0300

5.5.2

Instructions that Disable Interrupts

Instructions that disable interrupts are LDC, ANDC, ORC, and XORC. After any of these

instructions is executed, all interrupts including NMI are disabled and the next instruction is

always executed. When the I bit or UI bit is set by one of these instructions, the new value

becomes valid two states after execution of the instruction ends.

5.5.3

Times when Interrupts Are Disabled

There are times when interrupt acceptance is disabled by the interrupt controller.

The interrupt controller disables interrupt acceptance for a 3-state period after the CPU has

updated the mask level with an LDC, ANDC, ORC, or XORC instruction.

5.5.4

Interrupts during Execution of EEPMOV Instruction

Interrupt operation differs between the EEPMOV.B instruction and the EEPMOV.W instruction.

With the EEPMOV.B instruction, an interrupt request (including NMI) issued during the transfer

is not accepted until the move is completed.

With the EEPMOV.W instruction, if an interrupt request is issued during the transfer, interrupt

exception handling starts at a break in the transfer cycle. The PC value saved on the stack in this

case is the address of the next instruction.

Therefore, if an interrupt is generated during execution of an EEPMOV.W instruction, the

following coding should be used.

L1:

EEPMOV.W

MOV.W

R4,R4

BNE

5.5.5

IRQ Interrupt

When operating by clock input, acceptance of input to an IRQ is synchronized with the clock. In

software standby mode, the input is accepted asynchronously. For details on the input conditions,

see section 19.4.2, Control Signal Timing.

H8S2245 датащи(PDF) 169 Page - Renesas Technology Corp