SBPH400-3 datasheet(24/43 Pages) STMICROELECTRONICS

24 / 43 page

24/43

SBPH400-3

2.8.9 Receive

When the SBPH400 detects the “data-on” state on the serial bus, it starts the receive operation

by asserting receive on the CTL pins and ‘1’ on each of the D pins. The SBPH400 indicates

the beginning of the packet by placing on the D pins the speed code, as defined in Table 2.14.

The speed code is followed by the contents of the received packet using the appropriate range

of D pins (D[0:1] for S100, D[0:3] for S200 and D[0:7] for S400). The CTL pins will remain in

the receive state until the last symbol of the packet has been transferred to the link device. The

end of the packet is indicated by the CTL pins going back to the idle state. Note that the speed

code is part of the link interface protocol and is not included in the calculation of CRC. Note

that P1394a requires that, for compatibility with 1394-1995 PHYs, if “multi-speed

concatenated packets” is not enabled (see Table 2.16), any concatenated packet which is

received without a speed code is assumed to be transmitted at the same speed as the packet

to which it is concatenated. If the SBPH400 detects such a packet then it will indeed make this

assumption, and will supply the appropriate speed code in front of the packet as it transfers it

to the link device. The receive timing is shown in Figure 2.14.

Figure 2.13

Receive timing

Table 2.14

Speed codes on the LINK-PHY interface

D[0:7]

Data Rate

00000000

S100

01000000

S200

01010000

S400

11111111

“data-on” indication

CTL[0:1]

D[0:7] (hex)

SBPH400-3 датащи(PDF) 24 Page - STMicroelectronics