| поискавой системы для электроныых деталей |
|
SBPH400-3 датащи(PDF) 15 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
SBPH400-3 датащи(HTML) 15 Page - STMicroelectronics |
|
15 / 43 page ![]() SBPH400-3 15/43 Figure 2.9 Remote confirmation packet format The fields in the remote command and remote confirmation packets are interpreted as shown in Table 2.4. 2.8 Link interface 2.8.1 Overview The link interface in the SBPH400 operates as described in the IEEE P1394a proposal. The SBPH400 implements an interface to a single 1394 link layer device, using the pins D[0:7], Ctl[0:1], LREQ, SClk, LPS and LKON. The interface is scalable, using 2 data bits in parallel per 100 Mbit/sec. This enables the clock rate of the signals at this interface to remain at 50 MHz. Table 2.4 Remote Command and Confirmation packet fields Field Comment phy_ID Physical node identifier of the destination of the packet (type = 8) Physical node identifier of the source of the packet (type = A16) type 8 - remote command packet A16 - remote confirmation packet port Identify the port for the command or confirmation. For values other than 0, 1 and 2, the SBPH400 always responds with the OK bit set to zero in the confirmation packet. f current value of the Fault bit from SBPH400 register 10012 for the addressed port c current value of the Connected bit from SBPH400 register 10002 for the addressed port b current value of the Bias bit from SBPH400 register 10002 for the addressed port d current value of the Disabled bit from SBPH400 register 10002 for the addressed port ok 1 if the immediately preceding remote command was accepted by the SBPH400, zero otherwise cmnd type = 8:- 0 - NOP 1 - Transmit TX_DISABLE_NOTIFY then disable the port 2 - Initiate suspend 4 - Clear the port’s Fault bit 5 - Enable port 6 - Resume port type = A16:- The cmnd value from the immediately preceding remote command packet data Current value of the SBPH400 register addressed by the immediately preceding Remote Access packet (reserved and unimplemented fields and registers are returned as zero). 0 0 phy_ID logical inverse of first quadlet 0 port 000 cmnd 0 000 type(A16)f c b d ok 2 |
|
ссылки URL |
| Вашему бизинису помогли Аллдатащит? [ DONATE ] |
Что такое Аллдатащит | реклама | контакт | Конфиденциальность | Ссылка на техническое описание | обмен ссыками | поиск по производителю All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |