PM7367 datasheet(267/323 Pages) PMC

267 / 323 page

PM7367 FREEDM-32P32

DATA SHEET

PMC-1991499

ISSUE 2

FRAME ENGINE AND DATA LINK MANAGER

PROPRIETARY AND CONFIDENTIAL TO PMC-SIERRA, INC., AND FOR ITS CUSTOMER’S INTERNAL USE

253

bits is used to record status information for PCI bus related events. Reads to the

status portion of this register behave normally. Writes are slightly different in that

bits can be reset, but not set. A bit is reset whenever the register is written, and

the data in the corresponding bit location is a 1.

IOCNTRL:

When IOCNTRL is set to zero, the GPIC will not respond to PCI bus I/O

accesses.

MCNTRL:

When MCNTRL is set to one, the GPIC will respond to PCI bus memory

accesses. Clearing MCNTRL disables memory accesses.

MSTREN:

When MSTREN is set to one, the GPIC can act as a Master. Clearing

MSTREN disables the GPIC from becoming a Master.

SPCEN:

The GPIC does not decode PCI special cycles. The SPCEN bit is forced low.

MWAI:

The GPIC does not generate memory-write-and-invalidate commands. The

MWAI bit is forced low.

VGASNP:

The GPIC is not a VGA device. The VGASNP bit is forced low.

PERREN:

When the PERREN bit is set to one, the GPIC can report parity errors.

Clearing the PERREN bit causes the GPIC to ignore parity errors.

ADSTP:

The GPIC does not perform address and data stepping. The ADSTP bit is

forced low.

SERREN:

When the SERREN bit is set high, the GPIC can drive the SERRB line.

Clearing the SERREN bit disables the SERRB line. SERREN and PERREN

must be set to report an address parity error.

PM7367 датащи(PDF) 267 Page - PMC-Sierra, Inc