| поискавой системы для электроныых деталей |
|
NAND512R3A2C датащи(PDF) 20 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
NAND512R3A2C датащи(HTML) 20 Page - STMicroelectronics |
|
20 / 51 page ![]() Device operations NAND512-A2C 20/51 Figure 7. Pointer operations for programming 6.2 Read Memory Array Each operation to read the memory area starts with a pointer operation as shown in the Section 6.1: Pointer operations. Once the area (main or spare) has been selected using the Read A, Read B or Read C commands four bus cycles (for 512Mb and 1Gb devices) or three bus cycles (for 128Mb and 256Mb devices) are required to input the address (refer to Table 6 and Table 7) of the data to be read. The device defaults to Read A mode after power-up or a Reset operation. When reading the spare area addresses: ● A0 to A3 (x8 devices) ● A0 to A2 (x16 devices) are used to set the start address of the spare area while addresses: ● A4 to A7 (x8 devices) ● A3 to A7 (x16 devices) are ignored. Once the Read A or Read C commands have been issued they do not need to be reissued for subsequent read operations as the pointer remains in the respective area. However, the Read B command is effective for only one operation, once an operation has been executed in Area B the pointer returns automatically to Area A and so another Read B command is required to start another read operation in Area B. Once a read command is issued two types of operations are available: Random Read and Page Read. 6.2.1 Random Read Each time the command is issued the first read is Random Read. ai07591 I/O Address Inputs Data Input 10h 80h Areas A, B, C can be programmed depending on how much data is input. Subsequent 00h commands can be omitted. AREA A 00h Address Inputs Data Input 10h 80h 00h I/O Address Inputs Data Input 10h 80h Areas B, C can be programmed depending on how much data is input. The 01h command must be re-issued before each program. AREA B 01h Address Inputs Data Input 10h 80h 01h I/O Address Inputs Data Input 10h 80h Only Areas C can be programmed. Subsequent 50h commands can be omitted. AREA C 50h Address Inputs Data Input 10h 80h 50h |
|
ссылки URL |
| Вашему бизинису помогли Аллдатащит? [ DONATE ] |
Что такое Аллдатащит | реклама | контакт | Конфиденциальность | Ссылка на техническое описание | обмен ссыками | поиск по производителю All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |