IA186EM-PQF100I-R datasheet(58/133 Pages) INNOVASIC

58 / 133 page

IA186EM/IA188EM

Data Sheet

8/16-BIT Microcontrollers

As of Production Version -03

Asynchronous Serial Port

The asynchronous serial port employs standard industry communication protocols in its implementation

of full duplex, bi-directional data transfers. The port can be the source or destination of DMA transfers.

The following features are supported:

" Full-duplex data transfers

" 7-, 8-, or 9-bit data transfers

" Odd, even, or no parity

" One or two stop bits

" Error detection provided by Parity, Framing, or Overrun errors

" Hardware handshaking is achieved with the following selectable control signals: Clear-to-send (cts_n)

o Enable receiver request (enrx_n)

o Ready to send (rts_n)

o Ready to receive (rtr_n)

" DMA to and from the port

" The port has its own maskable interrupt

" The port has an independent baud rate generator

" Maximum baud rate is 1/32 of the processor clock

" Transmit and Receive lines are double buffered

In power-save mode the baud rate generator divide factor must be re-programmed to compensate for the

change in clock rate.

Synchronous Serial Port

The synchronous serial port allows the microcontrollers to communicate with ASICs that are required to

be programmed but have a pin shortage. The four-pin interface allows half-duplex, bi-directional data

transfer at a maximum of 20 Mbits/sec with a 40 MHz CPU clock.

The synchronous serial interface of the AI186EM/AI188EM operates as the master port in a master/slave

arrangement.

There are four pins in the synchronous serial interface for communication with the system elements.

These pins are two enables (SDEN0 and SDEN1), a clock (SCLK) and a data pin (SDATA).

In power-save mode, the baud rate generator divide factor must be re-programmed to compensate for the

change in clock rate.

3737 Princeton NE, Ste 130 • Albuquerque, NM 87107 • Tel 505.883.5263 • Fax 505.883.5477 • www.Innovasic.com

IA186EM-PQF100I-R датащи(PDF) 58 Page - InnovASIC, Inc