| поискавой системы для электроныых деталей |
|
DP83848C датащи(PDF) 11 Page - National Semiconductor (TI) |
|
|
|
|||||||||||||||||||||||||||||
DP83848C датащи(HTML) 11 Page - National Semiconductor (TI) |
|
11 / 82 page ![]() 11 www.national.com 1.3 Clock Interface 1.4 LED Interface See Table 3 for LED Mode Selection. Signal Name Type Pin # Description X1 I 34 CRYSTAL/OSCILLATOR INPUT: This pin is the primary clock reference input for the DP83848C and must be connected to a 25 MHz 0.005% (+50 ppm) clock source. The DP83848C supports either an external crystal resonator connected across pins X1 and X2, or an external CMOS-level oscillator source connected to pin X1 only. RMII REFERENCE CLOCK: This pin is the primary clock refer- ence input for the RMII mode and must be connected to a 50 MHz 0.005% (+50 ppm) CMOS-level oscillator source. X2 O 33 CRYSTAL OUTPUT: This pin is the primary clock reference out- put to connect to an external 25 MHz crystal resonator device. This pin must be left unconnected if an external CMOS oscillator clock source is used. 25MHz_OUT O 25 25 MHz CLOCK OUTPUT: In MII mode, this pin provides a 25 MHz clock output to the sys- tem. In RMII mode, this pin provides a 50 MHz clock output to the sys- tem. This allows other devices to use the reference clock from the DP83848C without requiring additional clock sources. Signal Name Type Pin # Description LED_LINK S, O, PU 28 LINK LED: In Mode 1, this pin indicates the status of the LINK. The LED will be ON when Link is good. LINK/ACT LED: In Mode 2 and Mode 3, this pin indicates transmit and receive activity in addition to the status of the Link. The LED will be ON when Link is good. It will blink when the transmitter or receiver is active. LED_SPEED S, O, PU 27 SPEED LED: The LED is ON when device is in 100 Mb/s and OFF when in 10 Mb/s. Functionality of this LED is independent of mode selected. LED_ACT/COL S, O, PU 26 ACTIVITY LED: In Mode 1, this pin is the Activity LED which is ON when activity is present on either Transmit or Receive. COLLISION/DUPLEX LED: In Mode 2, this pin by default indi- cates Collision detection. For Mode 3, this LED output may be programmed to indicate Full-duplex status instead of Collision. |
|
ссылки URL |
| Вашему бизинису помогли Аллдатащит? [ DONATE ] |
Что такое Аллдатащит | реклама | контакт | Конфиденциальность | Ссылка на техническое описание | обмен ссыками | поиск по производителю All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |