MC68340 datasheet(109/441 Pages) FREESCALE

109 / 441 page

4- 12

MC68340 USER’S MANUAL

MOTOROLA

this compare is low-pass filtered and used to control the VCO. The comparator also

detects when the external crystal or oscillator stops running to initiate the limp mode for

the system clock.

The PLL requires an external low-leakage filter capacitor, typically in the range from 0.01

to 0.1

µF, connected between the XFC and VCCSYN pins. The XFC capacitor should

provide 50-M

Ω insulation but should not be electrolytic. Smaller values of the external filter

capacitor provide a faster response time for the PLL, and larger values provide greater

frequency stability. For external clock mode without PLL, the XFC pin can be left open.

4.2.3.2 FREQUENCY DIVIDER. The frequency divider circuits divide the VCO frequency

down to the reference frequency for the phase comparator. The frequency divider consists

of 1) a 2-bit prescaler controlled by the W-bit in the SYNCR and 2) a 6-bit modulo

downcounter controlled by the Y-bits in the SYNCR.

Several factors are important to the design of the system clock. The resulting system clock

frequency must be within the limits specified for the device. The frequency of the system

clock is given by the following equation:

FSYSTEM = FCRYSTAL [2

(2+2W+X) ]

× (Y+1)

The maximum VCO frequency limit must also be observed. The VCO frequency is given

by the following equation:

FVCO = FSYSTEM [2

(2–X)]

Since clearing the X-bit causes the VCO to run at twice the system frequency, the VCO

upper frequency limit must be considered when programming the SYNCR. Both the

system clock and VCO frequency limits are given in Section 11 Electrical

Characteristics. Table 4-2 lists some frequencies available from various combinations of

SYNCR bits with a reference frequency of 32.768-KHz.

Freescale Semiconductor, Inc.

For More Information On This Product,

Go to: www.freescale.com

MC68340 датащи(PDF) 109 Page - Freescale Semiconductor, Inc