68HC705SP7 datasheet(74/230 Pages) NXP

74 / 230 page

Operating Modes

General Release Specification

MC68HC705JJ7/MC68HC705JP7 — Rev. 3.0

Operating Modes

•

An external interrupt signal on a port A external interrupt pin — If

selected by the PIRQ bit in the MOR, a low-to-high transition on a

PA3–PA0 pin loads the program counter with the contents of

locations $1FFA and $1FFB.

•

External reset — A logic zero on the RESET pin resets the MCU

and loads the program counter with the contents of locations

$1FFE and $1FFF.

When the MCU exits stop mode, processing resumes after a

stabilization delay of 16 or 4064 internal bus cycles, depending on the

state of the DELAY bit in the MOR.

NOTE:

Execution of the STOP instruction without setting the SWAIT bit in the

MOR will cause the oscillators to stop, and, therefore, disable the COP

watchdog timer. If the COP watchdog timer is to be used, stop mode

should be changed to halt mode as described in 6.4.3 Halt Mode.

6.4.2 Wait Mode

The WAIT instruction puts the MCU in a low-power wait mode which

consumes more power than the stop mode and affects the MCU as

follows:

•

Enables interrupts by clearing the I bit in the condition code

•

Enables external interrupts by setting the IRQE bit in the IRQ

status and control register

•

Stops the CPU clock which drives the address and data buses, but

allows the selected oscillator to continue to clock the core timer,

programmable timer, analog subsystem, and SIOP

The WAIT instruction does not affect any other bits, registers, or I/O

lines.

Freescale Semiconductor, Inc.

For More Information On This Product,

Go to: www.freescale.com

68HC705SP7 датащи(PDF) 74 Page - NXP Semiconductors