AT25SL321 datasheet(30/82 Pages) DIALOG

номер детали	AT25SL321

подробное описание детали	32-Mbit, 1.7 V Minimum SPI Serial Flash Memory with Dual I/O, Quad I/O and QPI Support

PDF	82 Pages

Scroll/Zoom	100%

производитель	DIALOG [Dialog Semiconductor]

домашняя страница	http://www.dialog-semiconductor.com/

Logo

30 / 82 page

AT25SL321

DS-25SL321–112H–2020-10

8.14 Fast Read Quad I/O (EBh)

The Fast Read Quad I/O instruction reduces cycle overhead through quad access using four IO pins: IO0, IO1,

IO2, and IO3. The Quad Enable bit (QE) of Status Register-2 must be set to enable the Fast read Quad I/O

Instruction.

Continuous Read Mode

The Fast Read Quad I/O instruction can further reduce instruction overhead through setting the Mode bits (M7-

0) with following the input Address bits (A23-0), as shown in Figure 8-18. The upper nibble of the Mode (M7-4)

controls the length of the next Fast Read Quad I/O instruction through the inclusion or exclusion of the first byte

instruction code. The lower nibble bits of the Mode (M3-0) are don’t care (“X”). However, the IO pins are going to

be high-impedance prior to the falling edge of the first data out clock.

If the Mode bits (M7-0) equal “Ax” hex, then the next Fast Read Quad I/O instruction (after CS is raised and then

lowered) does not require the EBh instruction code, as shown in Figure 8-19. This reduces the instruction

sequence by eight clocks and allows the address to be immediately entered after CS is asserted low. If the

Mode bits (M7-0) are any value other than “Ax” hex, the next instruction (after CS is raised and then lowered)

requires the first byte instruction code, thus retuning normal operation. A Mode Bit Reset can be used to reset

Mode Bits (M7-0) before issuing normal instructions.

Figure 8-18. Fast Read Quad I/O Instruction (Initial instruction or previous M7-0 ≠ Axh, SPI mode)

Figure 8-19. Fast Read Quad I/O Instruction (previous M7-0 = Axh, SPI mode)

AT25SL321 датащи(PDF) 30 Page - Dialog Semiconductor