AT25QL321 datasheet(26/79 Pages) DIALOG

номер детали	AT25QL321

подробное описание детали	32-Mbit, 1.7V Minimum SPI Serial Flash Memory with Dual I/O, Quad I/O and QPI Support

PDF	79 Pages

Scroll/Zoom	100%

производитель	DIALOG [Dialog Semiconductor]

домашняя страница	http://www.dialog-semiconductor.com/

Logo

26 / 79 page

AT25QL321

DS-25QL321–131C–5/2017

Figure 7-17. Fast Read Dual I/O Instruction (previous M7‐0= Axh)

7.14 Fast Read Quad I/O (EBh)

The Fast Read Quad I/O instruction reduces cycle overhead through quad access using four IO pins: IO0, IO1, IO2, and IO3.

The Quad Enable bit (QE) of Status Register-2 must be set to enable the Fast read Quad I/O Instruction.

Continuous read mode

The Fast Read Quad I/O instruction can further reduce instruction overhead through setting the Mode bits (M7-0) with

following the input Address bits (A23-0), as shown in Figure 7-18. The upper nibble of the Mode (M7-4) controls the

length of the next Fast Read Quad I/O instruction through the inclusion or exclusion of the first byte instruction code.

The lower nibble bits of the Mode (M3-0) are don’t care (“X”). However, the IO pins should be high-impedance prior to

the falling edge of the first data out clock.

If the Mode bits (M7‐0) equal “Ax” hex, then the next Fast Read Quad I/O instruction (after CS is raised and then

lowered) does not require the EBh instruction code, as shown in Figure 7-19. This reduces the instruction sequence

by eight clocks and allows the address to be immediately entered after CS is asserted low. If the Mode bits (M7‐0)

are any value other than “Ax” hex, the next instruction (after CS is raised and then lowered) requires the first byte

instruction code, thus retuning normal operation. A Mode Bit Reset can be used to reset Mode Bits (M7‐0) before issuing

normal instructions.

AT25QL321 датащи(PDF) 26 Page - Dialog Semiconductor