AT25DF641A datasheet(22/58 Pages) DIALOG

номер детали	AT25DF641A

подробное описание детали	64-Mbit, 2.7V Minimum SPI Serial Flash Memory with Dual?밒/O Support

PDF	58 Pages

Scroll/Zoom	100%

производитель	DIALOG [Dialog Semiconductor]

домашняя страница	http://www.dialog-semiconductor.com/

Logo

22 / 58 page

AT25DF641A [DATASHEET]

8793F–DFLASH–11/2017

Protection Commands and Features

9.1

Write Enable

The Write Enable command is used to set the Write Enable Latch (WEL) bit in the Status Register to a Logical 1 state.

The WEL bit must be set before a Byte/Page Program, Erase, Protect Sector, Unprotect Sector, Sector Lockdown,

Freeze Sector Lockdown State, Program OTP Security Register, or Write Status Register command can be executed.

This makes the issuance of these commands a two-step process, thereby reducing the chances of a command being

accidentally or erroneously executed. If the WEL bit in the Status Register is not set prior to the issuance of one of these

commands, then the command will not be executed.

To issue the Write Enable command, the CS pin must first be asserted and the opcode of 06h must be clocked into the

device. No address bytes need to be clocked into the device, and any data clocked in after the opcode will be ignored.

When the CS pin is deasserted, the WEL bit in the Status Register will be set to a Logical 1. The complete opcode must

be clocked into the device before the CS pin is deasserted, and the CS pin must be deasserted on an even byte

boundary (multiples of eight bits); otherwise, the device will abort the operation and the state of the WEL bit will not

change.

Figure 9-1. Write Enable

SCK

MSB

00000110

Opcode

High-impedance

AT25DF641A датащи(PDF) 22 Page - Dialog Semiconductor