AT25DF641A datasheet(39/58 Pages) DIALOG

39 / 58 page

AT25DF641A [DATASHEET]

8793F–DFLASH–11/2017

11.1.6 RSTE Bit

The RSTE bit is used to enable or disable the Reset command. When the RSTE bit is in the Logical 0 state (the default

state after power-up), the Reset command is disabled and any attempts to reset the device using the Reset command

will be ignored. When the RSTE bit is in the Logical 1 state, the Reset command is enabled.

The RSTE bit will retain its state as long as power is applied to the device. Once set to the Logical 1 state, the RSTE bit

will remain in that state until it is modified using the Write Status Register Byte 2 command or until the device has been

power cycled. The Reset command itself will not change the state of the RSTE bit.

11.1.7 SLE Bit

The SLE bit is used to enable and disable the Sector Lockdown and Freeze Sector Lockdown State commands. When

the SLE bit is in the Logical 0 state (the default state after power-up), the Sector Lockdown and Freeze Sector Lockdown

commands are disabled. If the Sector Lockdown and Freeze Sector Lockdown commands are disabled, then any

attempts to issue the commands will be ignored. This provides a safeguard for these commands against accidental or

erroneous execution. When the SLE bit is in the Logical 1 state, the Sector Lockdown and Freeze Sector Lockdown

State commands are enabled.

Unlike the WEL bit, the SLE bit does not automatically reset after certain device operations. Therefore, once set, the SLE

bit will remain in the Logical 1 state until it is modified using the Write Status Register Byte 2 command or until the device

has been power cycled. The Reset command has no effect on the SLE bit.

If the Freeze Sector Lockdown State command has been issued, then the SLE bit will be permanently reset in the

Logical 0 state to indicate that the Sector Lockdown command has been disabled.

11.1.8 PS Bit

The PS bit indicates whether or not a sector is in the Program Suspend state.

11.1.9 ES Bit

The ES bit indicates whether or not a sector is in the Erase Suspend state.

11.1.10 RDY/BSY Bit

The RDY/BSY bit is used to determine whether or not an internal operation, such as a program or erase, is in progress.

To poll the RDY/BSY bit to detect the completion of a program or erase cycle, new Status Register data must be

continually clocked out of the device until the state of the RDY/BSY bit changes from a Logical 1 to a Logical 0.

Figure 11-1. Read Status Register

SCK

MSB

00000101

410 11

812

21 22

15 16

13 14

23 24

28 29

Opcode

MSB

DDDDDD

MSB

DDDDDD

Status Register

Byte 1

Status Register

Byte 1

Status Register

Byte 2

High-impedance

AT25DF641A датащи(PDF) 39 Page - Dialog Semiconductor

AT25DF641A датащи(HTML) 39 Page - Dialog Semiconductor

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58

датащи скачать

ссылки URL