L9026 datasheet(37/60 Pages) STMICROELECTRONICS

37 / 60 page

SPI

The SPI interface is used to configure the device, control the outputs and read diagnostic and status registers.

11.1

SPI protocol

The serial peripheral interface (SPI) is a full duplex synchronous serial out-of-frame slave interface, with four

lines: SO, SI, CLK and NCS. Data is transferred by the lines MOSI and MISO at the rate given by CLK.

Considering the out-of-frame protocol implemented, it is important to ignore the first MISO received at the start of

communication because is meaningless.

The falling edge of NCS defines the start of the SPI frames. L9026 samples the MOSI line (SI) at the rising edge

of CLK while the output data is shifted out on line MISO (SO) at the falling edge of CLK. (CPOL=’0’, CPHA = ‘0’).

End of SPI access is defined by a rising edge of NCS.

L9026 implements feature to guarantee that SPI frame is considered valid when at least 16 bits have been

transferred: in case of transaction with less than 16 bit is received, the frame will be discarded and ERR bit is

asserted in next SPI frame. An SPI access with frame longer than 16 bits will be not discarded in order to allow

daisy chain operation.

As additional safety feature, the protocol is also equipped with 1 PARITY bit (odd parity) and a 1 bit frame counter;

the frame counter value to be considered at the beginning of a new communication session after a reset action

is "0". In case an incorrect frame counter value is detected, ERR bit is asserted in next SPI frame. The detailed

structure of MOSI and MISO frames is shown in Section 11.5 SPI frame structure.

The relationship between MOSI and MISO content during SPI communication is shown in Figure 19: the protocol

implements an out-of-frames strategy.

Figure 19. SPI out-of-frame protocol

During the Limp Home the SPI is in read only mode while no SPI access is possible during device Sleep Mode:

eventual frames are ignored and MISO pin remains in high impedance.

L9026

SPI

DS13397 - Rev 5

page 37/60

L9026 датащи(PDF) 37 Page - STMicroelectronics