| поискавой системы для электроныых деталей |
|
STM8S датащи(PDF) 196 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
STM8S датащи(HTML) 196 Page - STMicroelectronics |
|
196 / 467 page ![]() 16-bit advanced control timer (TIM1) RM0016 196/467 DocID14587 Rev 14 17.7.7 Status register 2 (TIM1_SR2) Address offset: 0x06 Reset value: 0x00 r Bit 2 CC2IF: Capture/compare 2 interrupt flag Refer to CC1IF description Bit 1 CC1IF: Capture/compare 1 interrupt flag If channel CC1 is configured as output: This flag is set by hardware when the counter matches the compare value, with some exception in center-aligned mode (refer to the CMS bits from TIM1_CR1 register description). It is cleared by software. 0: No match 1: The content of the counter register TIM1_CNT matches the content of the TIM1_CCR1 register Note: When the contents of TIMx_CCRi are greater than the contents of TIMx_ARR, the CCiIF bit goes high on the counter overflow (in up-counting and up/down-counting modes) or underflow (in down-counting mode) If channel CC1 is configured as input: This bit is set by hardware on a capture. It is cleared by software or by reading the TIM1_CCR1L register. 0: No input capture has occurred 1: The counter value has been captured in the TIM1_CCR1 register (an edge has been detected on IC1 which matches the selected polarity). Bit 0 UIF: Update interrupt flag This bit is set by hardware on an update event. It is cleared by software. 0: No update has occurred 1: Update interrupt pending. This bit is set by hardware when the registers are updated: – At overflow or underflow if UDIS = 0 in the TIM1_CR1 register – When CNT is re-initialized by software using the UG bit in TIM1_EGR register, if URS = 0 and UDIS = 0 in the TIM1_CR1 register. – When CNT is re-initialized by a trigger event (refer to the TIM1_SMCR register description), if URS = 0 and UDIS = 0 in the TIM1_CR1 register. 7 654 3210 Reserved CC4OF CC3OF CC2OF CC1OF Reserved r rc_w0 rc_w0 rc_w0 rc_w0 r Bits 7:5 Reserved, must be kept cleared Bit 4 CC4OF: Capture/compare 4 overcapture flag Refer to CC1OF description Bit 3 CC3OF: Capture/compare 3 overcapture flag Refer to CC1OF description |
|
ссылки URL |
| Вашему бизинису помогли Аллдатащит? [ DONATE ] |
Что такое Аллдатащит | реклама | контакт | Конфиденциальность | Ссылка на техническое описание | обмен ссыками | поиск по производителю All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |