STM8S datasheet(74/467 Pages) STMICROELECTRONICS

74 / 467 page

Reset (RST)

RM0016

74/467

DocID14587 Rev 14

Reset (RST)

There are 9 reset sources:

•

External reset through the NRST pin

•

Power-on reset (POR)

•

Brown-out Reset (BOR)

•

Independent watchdog reset (IWDG)

•

Window watchdog reset (WWDG)

•

Software reset

•

SWIM reset

•

Illegal opcode reset

•

EMC reset: generated if critical registers are corrupted or badly loaded

These sources act on the RESET pin and it is always kept low during the delay phase. The

RESET service routine vector is fixed at address 6000h in the memory map.

Figure 18. Reset circuit

8.1

“Reset state” and “under reset” definitions

When a reset occurs, there is a reset phase from the external pin pull-down to the internal

reset signal release. During this phase, the microcontroller sets some hardware

configurations before going to the reset vector.

At the end of this phase, most of the registers are configured with their “reset state” values.

During the reset phase, i.e. “under reset”, some pin configurations may be different from

their “reset state” configuration.

8.2

Reset circuit description

The NRST pin is both an input and an open-drain output with integrated RPU weak pull-up

resistor.

The low pulse of duration tINFP(NRST) on the NRST pin generates an external reset. The

reset detection is asynchronous and therefore the MCU can enter reset even in Halt mode.

The NRST pin also acts as an open-drain output for resetting external devices.

STM8S датащи(PDF) 74 Page - STMicroelectronics

STM8S датащи(HTML) 74 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

датащи скачать

ссылки URL