LPC2131 datasheet(12/41 Pages) PHILIPS

12 / 41 page

9397 750 14868

Preliminary data sheet

Rev. 02 — 15 April 2005

12 of 41

Philips Semiconductors

LPC2131/2132/2134/2136/2138

Single-chip 16/32-bit microcontrollers

Functional description

6.1 Architectural overview

The ARM7TDMI-S is a general purpose 32-bit microprocessor, which offers high

performance and very low power consumption. The ARM architecture is based on

Reduced Instruction Set Computer (RISC) principles, and the instruction set and related

decode mechanism are much simpler than those of microprogrammed Complex

Instruction Set Computers. This simplicity results in a high instruction throughput and

impressive real-time interrupt response from a small and cost-effective processor core.

Pipeline techniques are employed so that all parts of the processing and memory systems

can operate continuously. Typically, while one instruction is being executed, its successor

is being decoded, and a third instruction is being fetched from memory.

The ARM7TDMI-S processor also employs a unique architectural strategy known as

Thumb, which makes it ideally suited to high-volume applications with memory

restrictions, or applications where code density is an issue.

The key idea behind Thumb is that of a super-reduced instruction set. Essentially, the

ARM7TDMI-S processor has two instruction sets:

• The standard 32-bit ARM set.

• A 16-bit Thumb set.

The Thumb set’s 16-bit instruction length allows it to approach twice the density of

standard ARM code while retaining most of the ARM’s performance advantage over a

traditional 16-bit processor using 16-bit registers. This is possible because Thumb code

operates on the same 32-bit register set as ARM code.

Thumb code is able to provide up to 65 % of the code size of ARM, and 160 % of the

performance of an equivalent ARM processor connected to a 16-bit memory system.

6.2 On-Chip Flash program memory

The LPC2131/2132/2134/2136/2138 incorporate a 32 kB, 64 kB, 128 kB, 256 kB and

512 kB Flash memory system respectively. This memory may be used for both code and

data storage. Programming of the Flash memory may be accomplished in several ways. It

may be programmed In System via the serial port. The application program may also

erase and/or program the Flash while the application is running, allowing a great degree

of ﬂexibility for data storage ﬁeld ﬁrmware upgrades, etc. When the

LPC2131/2132/2134/2136/2138 on-chip bootloader is used, 32/64/128/256/500 kB of

Flash memory is available for user code.

The LPC2131/2132/2134/2136/2138 Flash memory provides a minimum of 100,000

erase/write cycles and 20 years of data-retention.

6.3 On-Chip static RAM

On-Chip static RAM may be used for code and/or data storage. The SRAM may be

accessed as 8-bits, 16-bits, and 32-bits. The LPC2131/2132/2134/2136/2138 provide

8/16/32 kB of static RAM.

LPC2131 датащи(PDF) 12 Page - NXP Semiconductors

LPC2131 датащи(HTML) 12 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41

датащи скачать

ссылки URL