ECT25S80 datasheet(6/45 Pages) E-CMOS

6 / 45 page

E-CMOS Corp. (www.ecmos.com.tw)

Page 6 of 45

5B16N-Rev.F001

ECT25S80

8M BIT SPI NOR FLASH

1.Block = Uniform Block, and the size is 64K bytes.

2.Half block = Half Uniform Block, and the size is 32k bytes.

3.Sector = Uniform Sector, and the size is 4K bytes.

SPI Operation

Standard SPI Instructions

The ECT25S80 features a serial peripheral interface on 4 signals bus: Serial Clock (SCLK), Chip

Select (/CS), Serial Data Input (SI) and Serial Data Output (SO). Both SPI bus mode 0 and 3 are

supported. Input data is latched on the rising edge of SCLK and data shifts out on the falling edge

of SCLK.

Dual SPI Instructions

The ECT25S80 supports Dual SPI op

eration when using the “Dual Output Fast Read” and “Dual

I/O Fast Read” (3BH and BBH) instructions. These instructions allow data to be transferred to or

from the device at two times the rate of the standard SPI. When using the Dual SPI instruction the

SI and SO pins become bidirectional I/O pins: IO0 and IO1.

Quad SPI Instructions

The ECT25S80

supports Quad SPI operation when using the “Quad Output Fast Read”,“Quad I/O

Fast

Read” (6BH, EBH) instructions. These instructions allow data to be transferred t-o or from

the device at four times the rate of the standard SPI. When using the Quad SPI instruction the SI

and SO pins become bidirectional I/O pins: IO0 and IO1, and /WP and /HOLD pins become IO2

and IO3. Quad SPI instructions require the non-volatile Quad Enable bit (QE) in Status Register-2

to be set.

Operation Features

Supply Voltage

Operating Supply Voltage

Prior to selecting the memory and issuing instructions to it, a valid and stable VCC voltage within the specified

[VCC(min), VCC(max)] range must be applied (see operating ranges). In order to secure a stable DC supply

voltage, it is recommended to decouple the VCC line with a suitable capacitor (usually of the order of 10 nF to

100 nF) close to the VCC/VSS package pins.

This voltage must remain stable and valid until the end of the transmission of the instruction and, for a Write

instruction, until the completion of the internal write cycle (tW).

Power-up Conditions

When the power supply is turned on, VCC rises continuously from VSS to VCC. During this time, the Chip

Select (/CS) line is not allowed to float but should follow the

VCC voltage, it is therefore recommended to

connect the /CS line to VCC via a suitable pull-up resistor.

In addition, the Chip Select (/CS) input offers a built-in safety feature, as the /CS input is edge sensitive as

well as level sensitive: after power-up, the device does not become selected until a falling edge has first been

detected on Chip Select (/CS). This ensures that Chip Select (/CS) must have been High, prior to going Low to

start the first operation.

ECT25S80 датащи(PDF) 6 Page - E-CMOS Corporation

ECT25S80 датащи(HTML) 6 Page - E-CMOS Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45

датащи скачать

ссылки URL