| поискавой системы для электроныых деталей |
|
ADCS9888 датащи(PDF) 29 Page - National Semiconductor (TI) |
|
|
|
|||||||||||||||||||||||||||||
ADCS9888 датащи(HTML) 29 Page - National Semiconductor (TI) |
|
29 / 34 page ![]() Application Information (Continued) Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0 A6 A5 A4 A3 A2 A1 A0 R/W 100110 A0 Pin 0 6.2.5 Register Address BYTE ADCS9888 register addresses are an 8 bit value. Please refer to the Register Address table at the beginning of the datasheet for more detailed information. 6.2.6 Serial Interface Timeout The serial interface incorporates a timeout feature. This is present to ensure that the bus cannot become ‘locked’ if the master and slave become out of sync due to noise or other system issues. An internal timer is used to guarantee that the interface is reset if the SCL line is held low. This is used to prevent problems in the case where the ADCS9888 is driving a low on the SDA line and the master device is reset. This allows the master to reset the state of the serial interface on the ADCS9888 by simply driving a low on SCL for more than 50 ms. The serial bus interface circuitry will be reset to the idle state if the SCL line is held low for more than 50 ms. The bus may be reset to idle if the SCL line is held low from 25 to 50 ms. The bus will not be reset if the SCL line is held low for less than 25 ms. 6.3 Specific Types Of Transfers 6.3.1 Write to Single Register • Start Signal • Slave Address Byte (R/W Bit = 0) • Register Address Byte • Data Byte to Register • Stop Signal 6.3.2 Burst Write to Multiple (3) Registers • Start Signal • Slave Address Byte (R/W Bit = 0) • Register Address Byte • Data Byte to Register • Data Byte to Register+1 • Data Byte to Register+2 • Stop Signal 6.3.3 Read from Single Register • Start Signal • Slave Address Byte (R/W Bit = 0) • Register Address Byte • Start Signal • Slave Address Byte (R/W Bit = 1) • Data Byte to Register • Stop Signal 6.3.4 Read from Multiple (3) Registers • Start Signal • Slave Address Byte (R/W Bit = 0) • Register Address Byte • Start Signal • Slave Address Byte (R/W Bit = 1) • Data Byte to Register • Data Byte to Register+1 • Data Byte to Register+2 • Stop Signal www.national.com 29 |
|
ссылки URL |
| Вашему бизинису помогли Аллдатащит? [ DONATE ] |
Что такое Аллдатащит | реклама | контакт | Конфиденциальность | Ссылка на техническое описание | обмен ссыками | поиск по производителю All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |