ST7FOXA0 datasheet(92/123 Pages) STMICROELECTRONICS

92 / 123 page

Electrical characteristics

ST7FOXA0

92/123

Electrical characteristics

12.1

Parameter conditions

Unless otherwise specified, all voltages are referred to VSS.

12.1.1

Minimum and maximum values

Unless otherwise specified the minimum and maximum values are guaranteed in the worst

conditions of ambient temperature, supply voltage and frequencies by tests in production on

100% of the devices with an ambient temperature at TA = 25 °C and TA = TAmax (given by

the selected temperature range).

Data based on characterization results, design simulation and/or technology characteristics

are indicated in the table footnotes and are not tested in production. Based on

characterization, the minimum and maximum values refer to sample tests and represent the

mean value plus or minus three times the standard deviation (mean±3

Σ).

12.1.2

Typical values

Unless otherwise specified, typical data are based on TA = 25 °C, VDD = 5 V (for the

4.5 V

≤ VDD≤ 5.5 V voltage range). They are given only as design guidelines and are not

tested.

12.1.3

Typical curves

Unless otherwise specified, all typical curves are given only as design guidelines and are

not tested.

12.1.4

Loading capacitor

The loading conditions used for pin parameter measurement are shown in Figure 36.

Figure 36.

Pin loading conditions

12.1.5

Pin input voltage

The input voltage measurement on a pin of the device is described in Figure 37.

ST7 PIN

Obsolete

Product(s)

- Obsolete

Product(s)

ST7FOXA0 датащи(PDF) 92 Page - STMicroelectronics