UM0139 datasheet(4/38 Pages) STMICROELECTRONICS

4 / 38 page

Delivery Checklist

UM0139

4/38

Connection accessories for the DIP20 and SO20 packages:

Flex adapter with DIP20 connector (ref.: DB482A) for connection between your

probe and your application board.

A DIP20 to DIP20 device adapter (ref.: DB535).

Note:

The DIP20 pinout on the flex adapter is askew by 90°. You must place the DIP20 to DIP20

device adapter (ref.: DB535) between the flex adapter connector and a socket (not included)

on your application board socket in order to correctly emulate your DIP20 application.

A DIP20 to SO20 device adapter/socket (ref.: DB093).

Connection accessories for the SDIP32 and SO28 packages:

Flex adapter with SDIP32 connector (ref.: DB510) for connection between the

EMU3 probe and your application board.

An SDIP32 to S028 device adapter (ref.: DB359) with connection pins to install on

your application board.

ICD adapter (MB509) for connection to your application board when in-circuit

debugging ST7FLITEUS microcontrollers.

Note:

The ICD Adapter comes with 16-pin variants of the ST7FLITEUSx with 1K of Flash memory

(Package marking: ST7FLITEUSICD) and ST7FLITEU0x with 2K of Flash memory

(Package marking: ST7FLITEU0ICD). Select the device that corresponds to the

microcontroller that you are developing with and insert it in the SDIP16 socket on the ICD

Adapter.

Owners of other versions of ST7-EMU3 emulators can configure them to emulate the

ST7226x, ST7LITE families and the ST7DALI with the ST7MDT10-TEB kit. This kit includes

the ST7MDT10 TEB (ref.: DB509) to install in the probe, as well as the connection

accessories listed above (No. 2-5).

UM0139 датащи(PDF) 4 Page - STMicroelectronics