UM0139 datasheet(35/38 Pages) STMICROELECTRONICS

номер детали	UM0139

подробное описание детали	The ST7-EMU3 series emulators are the third generation of high-end emulators for ST7

PDF	38 Pages

Scroll/Zoom	100%

производитель	STMICROELECTRONICS [STMicroelectronics]

домашняя страница	http://www.st.com

Logo

35 / 38 page

UM0139

Changing the TEB in your ST7-EMU3 probe

35/38

Figure 25.

Removing the TEB

The board under the TEB – the Dedicated Emulation Board (DEB), should now be

visible (see Figure 26).

Identify the top and bottom faces of the TEB you wish to install. The bottom face is

distinguished by the presence of two or more flex cable connectors placed side by side.

The top face is distinguishable by two DEB connectors along the long edges of the

TEB. There is one 84-pin connector and one 64-pin connector, which match the DEB

connectors shown in Figure 26.

Figure 26.

DEB and TEB connectors

Install the replacement TEB in the EMU3 probe by inserting the male 84-pin/64-pin

connectors into the TEB’s female 84-pin/64-pin connectors (refer to Figure 26).

Because the connectors are asymmetric, there is only one possible connection

scheme.

Note:

For some TEBs, the microcontroller is mounted on a support and not soldered directly to the

board. In this case the TEB’s 84-pin and 64-pin connectors have an additional height of

5mm to allow enough room for the microcontroller. To compensate you will need to add a

10mm

5mm

The 84 and 64-pin

connectors on the DEB

TEB

10mm TEB support

with 5mm extension

UM0139 датащи(PDF) 35 Page - STMicroelectronics