UM0139 datasheet(7/38 Pages) STMICROELECTRONICS

7 / 38 page

UM0139

Connecting to the application board for emulation

7/38

Connecting to the application board for emulation

The following sections tell you how to:

●

select the adapters and accessories for the target MCU

●

connect the flex adapter to the TEB, which is housed in the EMU3 probe,

The target MCUs that are emulated by the ST7MDT10-EMU3 probe exist in various

microcontroller packages. To connect the emulator to your application board, you must

select the flex adapter, device adapter(s) and socket for the target microcontroller based on

its package. Table 2 indicates which TEB connector to use, and the connection accessories

required for emulation of each supported microcontroller package.

Caution:

Only use the flex adapters provided with the ST7MDT10-EMU3. Even though flex adapters

from other ST7-EMU3 series emulators may look similar, each flex adapter is designed for

use with the emulator that it is delivered with.

2.1

Connecting the flex adapter to the EMU3 probe

Turn the EMU3 probe upside-down, unscrew the retaining screw and slide the bottom

out as shown in Figure 3.

Figure 3.

Opening the bottom of the probe

Table 2.

TEB connectors and connection accessories for supported packages

MCU Package

TEB connector

(see Figure 4)

Flex adapter

Device Adapter

On application

socket/connector

DIP16

DB483A

none

DIP16

SO16

(150-mil width)

DB483A

DB489

Provided connection pins

SO8

DB483A

DB645

Provided connection pins

DIP8

DB483A

DB645 + DB646

DIP8

DFN8

DB483A

DB645 + DB715

Provided female connector

DIP20

DB482A

DB535

DIP20

SO20

DB482A

DB093

Provided connection pins

SDIP32

DB510

none

SDIP32

SO28

DB510

DB359

Provided connection pins

UM0139 датащи(PDF) 7 Page - STMicroelectronics

UM0139 датащи(HTML) 7 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38

датащи скачать

ссылки URL