| поискавой системы для электроныых деталей |
|
MPC823 датащи(PDF) 49 Page - Motorola, Inc |
|
|
|||||||||||||||||||||||||||||
MPC823 датащи(HTML) 49 Page - Motorola, Inc |
|
49 / 74 page ![]() Communication Processor Module MOTOROLA MPC823 REFERENCE MANUAL 16-427 • C/I_TXBD—The SMCx circuit interface channel transmit (TX) buffer descriptor is used by the communication processor module to report information about the circuit interface channel transmit byte. R—Ready 0 = The communication processor module clears this bit after transmission to indicate that the buffer descriptor is now available to the core. 1 = The core sets this bit to indicate that the data associated with this buffer descriptor is ready for transmission. Bits 1–7 and 14–15—Reserved These bits are reserved and must be set to 0. C/I DATA—Command/Indication Data Bits This field represents a 4-bit data field for circuit interface channel 0 and a 6-bit data field for circuit interface channel 1. It contains the data to be transmitted onto the circuit interface channel. For circuit interface channel 0, bits 10-13 contain the 4-bit data field and bits 8 and 9 are always written with zeros. For circuit interface channel 1, bits 8-13 contain the 6-bit data field. • TEMP1–4—These bits are used internally by the RISC microcontroller. 16.11.8.3 SMCx GCI COMMANDS. The following commands are issued to the CPM command register. • INIT TX AND RX PARAMS—This command initializes the transmit and receive parameters in the parameter RAM to their reset state and it is especially useful when switching protocols on a given serial channel. • TRANSMIT ABORT REQUEST—This receiver command can be issued when the MPC823 implements the monitor channel protocol. When it is issued, the MPC823 sends an abort request on the A bit. • TIMEOUT—This transmitter command can be issued when the MPC823 implements the monitor channel protocol and it is usually issued because the device is not responding or A bit errors are detected. The MPC823 sends an abort request on the E bit at the time this command is issued. 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 OFFSET + 0 R RESERVED C/I DATA RESERVED |
|
ссылки URL |
| Вашему бизинису помогли Аллдатащит? [ DONATE ] |
Что такое Аллдатащит | реклама | контакт | Конфиденциальность | Ссылка на техническое описание | обмен ссыками | поиск по производителю All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |