DDP3310B datasheet(10/60 Pages) MICRONAS

10 / 60 page

DDP 3310B

ADVANCE INFORMATION

Micronas

2.1.10. Picture Frame Generator

When the picture does not fill the total screen (height

or width too small) it is surrounded with black areas.

These areas (and more) can be colored with the pic-

ture frame generator. Another possibility is the inser-

tion of a vertical and a horizontal stripe into the picture.

This is done by switching over the RGB signal from the

matrix to the signal from the frame color register.

The width of each area (left, right, upper, lower) can be

adjusted separately. The generator starts on the right,

respectively lower side of the screen and stops on the

left, respectively upper side of the screen. This means,

it runs during horizontal, respectively vertical fly-

back.The color of the complete border can be stored in

a programmable frame color register. The format is

×4 bit RGB. The contrast can be adjusted separately.

If the start value for the generator is larger than the

stop value, the picture frame is inserted at the borders.

If the start value is smaller than the stop value a verti-

cal or horizontal stripe is inserted.

2.1.11. Scan Velocity Modulation

Picture tubes equipped with an appropriate yoke can

use the Scan Velocity Modulation signal to vary the

speed of the electron gun during the entire video scan

line depending on its content. Transitions from dark to

bright will first speed up and then slow down the scan;

vice-versa for the opposite transition (see Fig. 2–6).

The digital RGB input signal for the SVM is converted

to Y in a simple matrix. Then the Y signal is differenti-

ated by a filter of the transfer function 1

−Z−N, where N

is programmable from 1 to 6. With a coring some noise

can be suppressed. This is followed by a gain adjust-

ment and an adjustable limiter. The analog output sig-

nal is generated by an 8-bit D/A converter. The signal

delay can be adjusted by

±3.5 clocks in half-clock

steps in respect to the analog RGB output signals.

This is useful to adjust the different group delays of

analog RGB amplifiers to the one for the SVM yoke

current.

Fig. 2–6: SVM signal wave form

Ampl.

Beam

Current

SVM Yoke

Current

DDP3310B датащи(PDF) 10 Page - Micronas

DDP3310B датащи(HTML) 10 Page - Micronas

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60

датащи скачать

ссылки URL