TVP7002IPZP datasheet(23/58 Pages) TI1

23 / 58 page

TVP7002

www.ti.com

SLES206C – MAY 2007 – REVISED APRIL 2013

2C Host Interface

Communication with the TVP7002 device is via an I2C host interface. The I2C standard consists of two signals,

serial input/output data (SDA) line and input clock line (SCL), which carry information between the devices

connected to the bus. A third signal (I2CA) is used for slave address selection. Although an I2C system can be

multi-mastered, the TVP7002 can function as a slave device only.

Since SDA and SCL are kept open drain at logic high output level or when the bus is not driven, the user should

connect SDA and SCL to a positive supply voltage via a pullup resistor on the board. SDA is implemented

bidirectional. The slave addresses select, terminal 73 (I2CA), enables the use of two TVP7002 devices tied to the

same I2C bus, as it controls the least significant bit of the I2C device address

Table 9. I2C Host Interface Terminal Description

SIGNAL

TYPE

DESCRIPTION

I2CA

Slave address selection

SCL

Input clock line

SDA

I/O

Input/output data line

Reset and I

2C Bus Address Selection

The TVP7002 can respond to two possible chip addresses. The I2 slave address is continuously interpreted from

the logic level present at the I2CA terminal. The I2C slave address must be configured with an external

connection to either IOGND (I2C address = B8h) or IOVDD (I2C address= BAh). A 2.2-k

Ω pullup or pulldown

resistor may be used for this connection.

Table 10. I2C Host Interface Device Addresses

A0 (I2CA)

R/W

HEX

0(1)

1/0

B9h/B8h

1(2)

1/0

BBh/BAh

(1)

If I2CA terminal 73 is strapped to IOGND, I2C device address A0 is set to 0.

(2)

If I2CA terminal 73 is strapped to IOVDD, I2C device address A0 is set to 1.

2C Operation

Data transfers occur utilizing the following illustrated formats.

10111000

ACK

Subaddress

ACK

Send data

ACK

Read from I2C control registers

10111000

ACK

Subaddress

ACK

10111001

ACK

Receive data

NAK

S = I2C bus Start condition

P = I2C bus Stop condition

ACK = Acknowledge generated by the slave

NAK = Acknowledge generated by the master, for multiple byte read master with ACK each byte except last byte

Subaddress = Subaddress byte

Data = Data byte, if more than one byte of DATA is transmitted (read and write), the subaddress pointer is

automatically incremented

I2C bus address = Example shown that I2CA is in default mode; write (B8h), read (B9h).

Submit Documentation Feedback

Product Folder Links: TVP7002

TVP7002IPZP датащи(PDF) 23 Page - Texas Instruments

TVP7002IPZP датащи(HTML) 23 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58

датащи скачать

ссылки URL