CC2650MODAMOHT datasheet(29/40 Pages) TI1

29 / 40 page

CC2650MODA

www.ti.com

SWRS187A – AUGUST 2016 – REVISED AUGUST 2016

Submit Documentation Feedback

Product Folder Links: CC2650MODA

Detailed Description

Timer 0 is a general-purpose timer module (GPTM), which provides two 16-bit timers. The GPTM can be

configured to operate as a single 32-bit timer, dual 16-bit timers or as a PWM module.

Timer 1, Timer 2, and Timer 3 are also GPTMs. Each of these timers is functionally equivalent to Timer 0.

In addition to these four timers, the RF core has its own timer to handle timing for RF protocols; the RF

timer can be synchronized to the RTC.

The I2C interface is used to communicate with devices compatible with the I2C standard. The I2C interface

is capable of 100-kHz and 400-kHz operation, and can serve as both I2C master and I2C slave.

The TRNG module provides a true, nondeterministic noise source for the purpose of generating keys,

initialization vectors (IVs), and other random number requirements. The TRNG is built on 24 ring

oscillators that create unpredictable output to feed a complex nonlinear combinatorial circuit.

The watchdog timer is used to regain control if the system fails due to a software error after an external

device fails to respond as expected. The watchdog timer can generate an interrupt or a reset when a

predefined time-out value is reached.

The device includes a direct memory access (µDMA) controller. The µDMA controller provides a way to

offload data transfer tasks from the CM3 CPU, allowing for more efficient use of the processor and the

available bus bandwidth. The µDMA controller can perform transfer between memory and peripherals. The

µDMA controller has dedicated channels for each supported on-chip module and can be programmed to

automatically perform transfers between peripherals and memory as the peripheral is ready to transfer

more data. Some features of the µDMA controller include the following (this is not an exhaustive list):

•

Highly flexible and configurable channel operation of up to 32 channels

•

Transfer modes: memory-to-memory, memory-to-peripheral, peripheral-to-memory, and peripheral-to-

peripheral

•

Data sizes of 8, 16, and 32 bits

The AON domain contains circuitry that is always enabled, except in Shutdown mode (where the digital

supply is off). This circuitry includes the following:

•

The RTC can be used to wake the device from any state where it is active. The RTC contains three

compare and one capture registers. With software support, the RTC can be used for clock and

calendar operation. The RTC is clocked from the 32-kHz RC oscillator or crystal. The RTC can also be

compensated to tick at the correct frequency even when the internal 32-kHz RC oscillator is used

instead of a crystal.

•

The battery monitor and temperature sensor are accessible by software and give a battery status

indication as well as a coarse temperature measure.

CC2650MODAMOHT датащи(PDF) 29 Page - Texas Instruments

CC2650MODAMOHT датащи(HTML) 29 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40

датащи скачать

ссылки URL