ATmega16 datasheet(129/315 Pages) ATMEL

номер детали	ATMEGA16

подробное описание детали	8-bit AVR Microcontroller with 16K Bytes In-System Programmable Flash

PDF	315 Pages

Scroll/Zoom	100%

производитель	ATMEL [ATMEL Corporation]

домашняя страница	http://www.atmel.com

Logo

129 / 315 page

129

ATmega16(L)

2466E–AVR–10/02

Serial Peripheral

Interface – SPI

The Serial Peripheral Interface (SPI) allows high-speed synchronous data transfer

between the ATmega16 and peripheral devices or between several AVR devices. The

ATmega16 SPI includes the following features:

• Full-duplex, Three-wire Synchronous Data Transfer

• Master or Slave Operation

• LSB First or MSB First Data Transfer

• Seven Programmable Bit Rates

• End of Transmission Interrupt Flag

• Write Collision Flag Protection

• Wake-up from Idle Mode

• Double Speed (CK/2) Master SPI Mode

Figure 65. SPI Block Diagram(1)

Note:

1. Refer to Figure 1 on page 2, and Table 25 on page 55 for SPI pin placement.

The interconnection between Master and Slave CPUs with SPI is shown in Figure 66.

The system consists of two Shift Registers, and a Master clock generator. The SPI Mas-

ter initiates the communication cycle when pulling low the Slave Select SS pin of the

desired Slave. Master and Slave prepare the data to be sent in their respective Shift

Registers, and the Master generates the required clock pulses on the SCK line to inter-

change data. Data is always shifted from Master to Slave on the Master Out – Slave In,

MOSI, line, and from Slave to Master on the Master In – Slave Out, MISO, line. After

each data packet, the Master will synchronize the Slave by pulling high the Slave Select,

SS, line.

DIVIDER

/2/4/8/16/32/64/128

ATMEGA16 датащи(PDF) 129 Page - ATMEL Corporation