ML2721 datasheet(16/27 Pages) MICRO-LINEAR

16 / 27 page

ML2721

January, 2000

PRELIMINARY DATASHEET

PRELIMINARY

CONTROL INTERFACES

There are two control interfaces:

Parallel mode control. Controlling the mode of

operation of the ML2721. Refer to the Operational

Modes section for details.

Serial Interface. Programing the PLL signal and

reference dividers, internal test modes, and filter

alignment.

Other signal interfaces to the IC are:

n Receiver data output

n Transmit modulation data input

n PLL lock detect output, to indicate when the on chip

PLL is in frequency lock

n Receive RF input, the input to the receiver circuits

n Transmit RF output, the output for the modulated RF

signal

n Received signal strength output: RSSI indicates the

power of the received signal

n Reference frequency input for PLL dividers

Table 7. Control Logic

Bit Allocations

Data words are entered beginning with the MSB. The word

is divided into a leading 14-bit data field and a 2-bit

address field. When the address field has been decoded

the destination register is loaded on the rising edge of EN.

Providing less than 16 bits of data will result in

unpredictable behavior when EN goes high.

Parallel Interface

The chip is enabled by the XCEN (Transceiver enable)

signal. The operating mode is set by the two control lines

TX/RX (Transmit/Receive Mode) and PLLEN (PLL enable),

and the 3 wire serial data bus. The logic for XCEN, RXON

and PLLEN is given in Table 7.

ML2721 датащи(PDF) 16 Page - Micro Linear Corporation