LTC1418AIN datasheet(21/28 Pages) LINER

21 / 28 page

LTC1418

APPLICATIONS INFORMATION

THREE

STATE

BUFFER

THREE

STATE

BUFFER

• • •

SCLK*

EXTCLKIN*

EXT/INT*

BUSY

*PINS 16 TO 20 ARE LABELED WITH THEIR SERIAL FUNCTIONS

1418 F20

DOUT*

CLKOUT*

SHIFT

INTERNAL

CLOCK

16 CONVERSION CLOCK CYCLES

EOC

DATA

OUT

CLOCK

INPUT

• • •

SAR

Figure 20. Functional Block Diagram for Serial Mode (SER/PAR = High)

asynchronous clocks. To maintain accuracy the external

conversion clock frequency must be between 30kHz and

4.5MHz.) The SAR sends an end of conversion signal,

EOC, that gates the external conversion clock so that only

16 clock cycles can go into the SAR, even if the external

clock, EXTCLKIN, contains more than 16 cycles.

When CS and RD are low, these 16 cycles of conversion

clock (whether internally or externally generated) will

appear on CLKOUT during each conversion and then

CLKOUT will remain low until the next conversion. If

desired, CLKOUT can be used as a master clock to drive

the serial port. Because CLKOUT is running during the

conversion, it is important to avoid excessive loading that

can cause large supply transients and create noise. For

the best performance, limit CLKOUT loading to 20pF.

Serial Port

The serial port in Figure 20 is made up of a 16-bit shift

trolled by three inputs: SCLK, RD and CS. The serial port

has one output, DOUT, that provides the serial output

data.

The SCLK is used to clock the shift register. Data may be

clocked out with the internal conversion clock operating

as a master by connecting CLKOUT (Pin 18) to SCLK (Pin

17) or with an external data clock applied to D3 (SCLK).

The minimum number of SCLK cycles required to

transfer a data word is 14. Normally, SCLK contains 16

clock cycles for a word length of 16 bits; 14 bits with MSB

first, followed by two trailing zeros.

A logic high on RD disables SCLK and three-states DOUT.

In case of using a continuous SCLK, RD can be controlled

to limit the number of shift clocks to the desired number

(i.e., 16 cycles) and to three-state DOUT after the data

transfer.

A logic high on CS three-states the DOUT output buffer. It

also inhibits conversion when it is tied high. In power

shutdown mode (SHDN = low), a high CS selects sleep

mode while a low CS selects nap mode. For normal serial

port operation, CS can be grounded.

DOUT outputs the serial data; 14 bits, MSB first, on the

falling edge of each SCLK (see Figures 21 and 22). If 16

SCLKs are provided, the 14 data bits will be followed by

LTC1418AIN датащи(PDF) 21 Page - Linear Technology

LTC1418AIN датащи(HTML) 21 Page - Linear Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28

датащи скачать

ссылки URL