AN4228 datasheet(42/90 Pages) STMICROELECTRONICS

42 / 90 page

Firmware migration using the library

AN4228

42/90

DocID024110 Rev 5

4.5.2

Input mode

The example below shows how to configure an I/O in input mode (for example to be used as

an EXTI line) in STM32F1 series:

GPIO_InitStructure.GPIO_Pin = GPIO_Pin_x;

GPIO_InitStructure.GPIO_Mode = GPIO_Mode_IN_FLOATING;

GPIO_Init(GPIOy, &GPIO_InitStructure);

In STM32F3 series, you have to update this code as follows:

GPIO_InitStructure.GPIO_Pin = GPIO_Pin_x;

GPIO_InitStructure.GPIO_Mode = GPIO_Mode_IN;

GPIO_InitStructure.GPIO_PuPd = GPIO_PuPd_NOPULL; /* None, Pull-up or pull-

down */

GPIO_Init(GPIOy, &GPIO_InitStructure);

4.5.3

Analog mode

The example below shows how to configure an I/O in analog mode (for example, an ADC or

DAC channel) in STM32F1 series:

GPIO_InitStructure.GPIO_Pin = GPIO_Pin_x;

GPIO_InitStructure.GPIO_Mode = GPIO_Mode_AIN;

GPIO_Init(GPIOy, &GPIO_InitStructure);

In STM32F3 series, you have to update this code as follows:

GPIO_InitStructure.GPIO_Pin = GPIO_Pin_x ;

GPIO_InitStructure.GPIO_Mode = GPIO_Mode_AN;

GPIO_InitStructure.GPIO_PuPd = GPIO_PuPd_NOPULL ;

GPIO_Init(GPIOy, &GPIO_InitStructure);

4.5.4

Alternate function mode

STM32F1 series

The configuration to use an I/O as an alternate function depends on the peripheral mode

used; for example, the USART Tx pin should be configured as an alternate function push-

pull while the USART Rx pin should be configured as an input floating or an input pull-up.

To optimize the number of peripheral I/O functions for different device packages, it is

possible, by software, to remap some alternate functions to other pins. For example, the

USART2_RX pin can be mapped on PA3 (default remap) or PD6 (by software remap).

STM32F3 series

Whatever the peripheral mode used, the I/O must be configured as an alternate function,

then the system can use the I/O in the proper way (input or output).

The I/O pins are connected to on-board peripherals/modules through a multiplexer that

allows only one peripheral alternate function to be connected to an I/O pin at a time. In this

way, there can be no conflict between peripherals sharing the same I/O pin. Each I/O pin

AN4228 датащи(PDF) 42 Page - STMicroelectronics

AN4228 датащи(HTML) 42 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90

датащи скачать

ссылки URL